Care And Cleaning; Replacing The Light Bulb - GE 6 Cubic Foot Models Owner's Manual And Installation Instructions

GEAppliances.com
Wipe with a clean cloth lightly dampened
with kitchen appliance wax or mild liquid dish detergent. Dry and
polish with a clean, soft cloth.
Do not wipe the refrigerator with a soiled dish cloth or wet towel. These
may leave a residue that can erode the paint. Do not use scouring
pads, powdered cleaners, bleach or cleaners containing bleach
because these products can scratch and weaken the paint finish.
The finish on the outside of the refrigerator is
a high quality, baked-on paint finish. With proper care, it will stay new-
looking and rust-free for years. Apply a coat of kitchen/ appliance wax
when the refrigerator is new, and then at least twice a year.
leave an open box of baking soda in the
refrigerator.
If this is not practical, wring
excess moisture out of sponge or cloth when cleaning around the
control.
Use warm water and baking soda solution –about a tablespoon (15
ml) of baking soda to a quart (1 liter) of water. This both cleans and
neutralizes odors. Rinse and wipe dry.
Other parts of the refrigerator–including door gaskets, fruit and
vegetable drawers, and all plastic parts–can be cleaned the same way.
Do not wash any plastic refrigerator parts in the dishwasher.
Unplug the refrigerator before replacing a burned-out bulb. Setting
the controls to does not remove power to the light circuit.
The light bulb is located behind the temperature control housing and
is visible through the slots in the housing.
4
5
6
Using a Philips screwdriver, unscrew the lens and pull horizontally until
the lens is removed. Gently unscrew the light bulb and replace with a
bulb of 15 watts or less.
5