Mounting Surface-Mounted Boundary Layer Microphones, Microphone Buttons, Switch Boxes: Table | Lectern - Sennheiser SpeechLine IS microphone series Instruction Manual

Mounting and installing the products
MEB 102 MEB 102-L
MAS 1 MEB 104 MEB 104-L
MEB 102-L
MEB 102
MEB 104 MEB 104-L
MAS 1
18 | SpeechLine IS microphone series
Mounting surface-mounted boundary layer
microphones, microphone buttons, switch boxes:
table | lectern
Drilling a hole through the surface of the table or lectern
Once you have chosen a position for the product (see page 16):
Drill a hole with a diameter of 25 mm through the mounting surface
(plate thickness: 10 mm - 65 mm).
Mounting the MEB 102 (-L) | MEB 104 (-L) boundary layer microphones
1 Slide the first rubber ring over the threaded bolt of the microphone and
then insert the microphone into the drilled hole.
2 Orient the MEB 104 and MEB 104-L microphones towards the speaker.
Slide the second rubber ring over the threaded bolt and tighten the hex
nut.
1
Mounting the MAS 1 microphone button
1 Slide the first rubber ring over the threaded bolt of the microphone
button and then insert the microphone into the drilled hole.
2 Slide the second rubber ring over the threaded bolt and tighten the hex
nut.
1
25 mm
10 mm –
65 mm
2
MEB 104 | MEB 104-L
2