Advertisement
Quick Links
Advertisement
Related Manuals for Singer Cover Stitch Wide
Summary of Contents for Singer Cover Stitch Wide
- Page 1 Cover Stitch Wide...
- Page 2 Depending on which needle position is selected the width can be 5.6mm wide or 2.8 mm wide. Left Cover Needle Thread Right Cover Needle Thread Cover Stitch Looper Thread Cover Stitch Wide page 1...
- Page 3 Chain Stitch Looper Threaded (Brown) Upper Looper Clutch “C” Upper Knife Non-working Position Seam Guide Plate Installed Seam Width Dial “N” Stitch Length Dial “N” Presser Foot “N” Pressure Differential Feed Dial “N” Stitch Finger “R” Cover Stitch Wide page 2...
- Page 4 Cover Stitch Wide Turn Auto Tension Dial to “H”. Turn Stitch Length Dial to “N”. Disengage Upper Knife. The knife will not trim the fabric when it is disengaged. 1. Open Looper Cover. 2. Pull the movable knife holder (silver screw) to the right as far as it will go.
- Page 5 Turn Presser Foot Pressure Dial to “N”. Turn Differential Feed Dial to “N”. Turn Seam Width Dial to “N”. Set Stitch Finger to “R”. Cover Stitch Wide page 4...
- Page 6 If the looper was still engaged it would hit the Seam Guide Plate. 1. Turn handwheel until the Upper Looper is in the lowest position. 2. Push the clutch button to the left and up to disengage. Upper Looper Engaged Upper Looper Disengaged Cover Stitch Wide page 5...
- Page 7 2.Thread the top cover thread guide by pulling the thread towards the left until it slips under the guide. Then pull thread along the right side of the button as illustrated. 3. While holding the thread firmly, pull the thread between the tension disks. Cover Stitch Wide page 6...
- Page 8 Position the thread into the V cutout (B) on the threader. Firmly hold the thread tail with your left hand and pull threader lever (C) up into place (D). Gently pull 5-6” of thread to the back of the machine. “V” cutout Threader Lever Cover Stitch Wide page 7...
- Page 9 Thread Right Cover Stitch needle with regular thread. 1. Raise the Presser Foot to release the tension disks. Thread the left needle as illustrated 1-9. 2. Pass thread from back to the front through the thread guide 3. Thread the top cover thread guide by pulling the thread towards the left until it slips under the guide.
- Page 10 7. Thread the eye of the Right Cover Stitch Needle 8. Draw about 4 inches of the thread through the needle eye towards the back of the machine. 9. Place the thread to the back, under the Presser Foot. Lower foot and sew. Cover Stitch Wide page 9...
- Page 11 3. Thread the top cover thread guide by pulling the thread towards the left until it slips under the guide. Then pull the thread along the right side of the button as illustrated. 4. While holding the thread firmly, pull the thread between the tension disks. Cover Stitch Wide page 10...
- Page 12 7. Thread the eye of the Left Cover Stitch Needle 8. Draw about 4 inches of the thread through the needle eye towards the back of the machine. 9. Place the thread to the back, under the Presser Foot. Lower foot and sew. Cover Stitch Wide page 11...
- Page 13 Press a 1” hem into a knit fabric. Lift the Presser Foot to the highest position. Position the fabric right side up and under the needles. Align the fabric so that that the fabric fold is 1” to the right of the needles. Lower the Presser Foot.