Advertisement
Technical Specifications
MicroCam II CMOS Colour Camera
Sensor:
1/3"(8.5mm) Colour CMOS
Horizontal
Resolution:
380 TV lines
Auto Electronic Exposure: 1/60 - 1/15000 sec.
Minimum Illumination:
1 Lux@ f1.2
Signal to Noise Ratio:
>48dB
Board Lens:
5.6mm
View Angle:
60 degrees
Size:
16mm x 18mm, board lens
Video System:
PAL 50Hz (Australia, UK/Europe), NTSC 60Hz (USA and Canada)
Automatic Exposure / Gain / White balance.
MicroCam II 2.4GHz Transmitter
Fixed Channel:
2432MHz Frequency
band
RF Output Power:
CE and FCC and C-tick
compliant
Operating Power:
8V DC 200mA
Power Consumption:
100mA
Size:
22 x 22 x 25 mm
Antenna:
Omni-directional
Transmitting Range:
Up to 100M line of sight
Weight:
20 grams
Operating Temperature:
0° ~ 50°C
(32° ~ 122°F)
FCC Notice
We, Swann Communications of 10612 Shoemaker Avenue, Bldg B, Santa Fe Springs, CA 90670
USA, declare under our sole responsibility that the product:
SW-P-MC2
To which this declaration relates:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
MicroCam II 2.4GHz Receiver
Frequency:
4 Channels in 2.4 Ghz
frequency band*
Video input/output:
1V p-p @ 75 ohm
Audio input / output:
1Vp-p @ 600 ohm
Antenna:
50ohm SMA
Operating Power:
12V DC 300mA
Power Consumption:
250mA
Size:
92 x 78 x 23 mm
Swann Tech Support
E-mail Support
International e-mail
(We usually reply on the next working day)
Telephone Support
USA
: 877-274-3695 (Toll free Calls to Melbourne Australia)
International:
+61 3 84124610 (Calls to Melbourne Australia)
Swann Tech Support operating hours:
9am - 5.30pm Mon to Fri Australian EST (UTC/GMT+10)
3pm - 11.30pm Sun to Thurs US Pacific Standard Time (UTC/GMT -8)
4pm - 12.30am Sun to Thurs US Mountain Standard Time (UTC/GMT -7)
5pm - 01.30am Sun to Thurs US Central Standard Time (UTC/GMT -6)
6pm - 02.30am Sun to Thurs US Eastern Standard Time (UTC/GMT -5)
Subtract one hour from local US time during Australian Daylight Saving period
(approx Last Sunday of October to last Sunday of March)
Add one hour to local time during Daylight Savings period in the USA when it
applies in your region
See http://www.worldtimeserver.com for information on different time zones and
the time in Melbourne Australia compared to your local time.
www.swann.com.au
: tech@swann.com.au
Advertisement
