Filter Blocked In Water Inlet Hose - Siemens WM14Y591GB Instruction Manual And Installation Instructions

Filter blocked in water inlet hose

First, release water pressure in the supply hose:
1.
2.
3.
4.
5.
6.
34
Turn off the tap!
Select any programme (except Spin/Drain).
Select Start/Reload
seconds.
Press the button. Appliance is switched off. Pull out the
#
mains plug!
Clean the filter:
Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models: and/or for standard and Aqua-Secure models: and/or for standard and Aqua-Secure models:
Remove hose from the rear of the appliance. Remove hose from the rear of the appliance. Remove hose from the rear of the appliance.
Take out filter with pliers and clean. Take out filter with pliers and clean. Take out filter with pliers and clean.
Connect the hose and check for leaks. Connect the hose and check for leaks. Connect the hose and check for leaks.
. Leave programme for approx. 40
Ü