Vacuum tube single-ended class a integrated amplifier (8 pages)
Summary of Contents for Jas Audio Bravo 2.4
Page 1
OWNER’S MANUAL JAS Bravo 2.4 Vacuum Tube Integrated Amplifier NOTE: Before installing your new Bravo 2.4 audio amplifier, please read this manual carefully. It will inform you of the product specifications and also proper installation and operation procedures. For additional requests...
Bravo 2.4 OWNER’S MANUAL Introduction Thank you for purchasing the JAS Audio Bravo 2.4 Integrated Amplifier. Standing on the chassis immediate in front of the transformer casing are two 5Z3P rectifier tubes. On either side of the chassis are two KT88 drive stage tubes for each channel output, whereas the two 12AT7 driver tubes and the only 12AU7 tube for signal amplification are in the middle.
Preliminary Bravo 2.4 features an aluminum alloy panel of 8mm in thickness that holds the on-off knob on the left, analogue volume control knob in the middle and the selector on the right. Signal input to four sets of RCA connectors is selectable by turning the selector It is important to be careful with tube installation.
If necessary, document the damage with photographs and contact the carrier immediately. Caution: On reception, carefully remove your new Bravo 2.4 from its packing carton and examine it closely for signs of shipping damage. It is recommended to save all original packing cartons and crates to protect your amplifier from damage should you wish to store it or ship it for after-sales service.
This product has been designed and manufactured to the highest quality and standards. However, if something does go wrong with this product, JAS Audio and its national distributors warrant, free of charge, labor (exclusion may apply) and replacement parts in any country served by an official JAS Audio distributor.
Note: All Bravo 2.4 amplifiers have their own serial number (S/N xxxxx), marked on the back of the chassis and also printed on the exterior of the packing box.