Installation; Make Cutout And Installing Support Structure - DCS ADR148 Use And Care And Installation Manual

INSTAllATION

MAkE CUTOUT AND INSTAll SUPPORT STRUCTURE
1. Make a cut-out in your cabinet or island with the following dimensions (Fig. 3):
NOTE: Each corner of the cutout should be 90º for the Access Drawers to fit properly.
Vent*
Vent*
90º
* Island installation to use minimum of 3 vents
providing 10 sq. in. per vent (typical).
2. Place 2 X 4s to provide support for the Access Drawers structure in the locations indicated in the figure below (Fig. 4).
3. Board lengths are provided in the table below (Fig. 5).
To ensure proper drawer operation, be sure
your support boards are flat & level.
A
B
C
E
D
4. when installing your support boards, be
sure they are level.
5. Ensure that the bottom of the center
divider rests on top of the support
boards as shown (Fig. 4).
D
B
A
C
Fig. 3
1/2" Bottom of center divider to
*
island cutout
Fig. 4
A
Model
(-0,+1/8")
ADR148 46"
Vent*
ADR136 34"
ADR130 28"
ADR124 22"
Sticker location of
Model, Serial, Code Number
B
A
*Dependent on application. Top of 2x4's
FRONT VIew (TyPIcAL)
Support Board (typical)
5
cUTOUT DIMeNSIONS
B
c
(-0,+1/8")
20" 1.0" min.
20" 1.0" min.
20" 1.0" min.
20" 1.0" min.
SUPPORT BOARD DIMeNSIONS
Model A B c
48" 2 X 20" 1-1/2"* 3-1/2" min. 14 12
36" 20" 1-1/2"* 3-1/2" min. 14
30" 2 X 20" 1-1/2"* 3-1/2" min. 14 12
24" 20" 1-1/2"* 3-1/2" min. 14
Fig. 5
must be 1/2" above the bottom edge of
the cutout.
eND VIew (TyPIcAL)
For proper
support & drawer
operation, insure
that support
boards are level
front to back &
side to side.
Support Boards
(typical)
Fig. 6
D
1.0" min.
1.0" min.
1.0" min.
1.0" min.
D e
–
–