Servo System Check; Rf Switching Position; Af Switching Position Adjustments (Ma-335 Board) - Sony SLV-M10HF Service Manual

2-3.

SERVO SYSTEM CHECK

Unless otherwise specified, set the switches to the following
positions.
• INPUT SELECT switch ........................................... LINE 1
• TAPE SPEED switch ..................... SP (Remote commander)

2-3-1. RF Switching Position/

AF Switching Position Adjustments
(MA-335 Board)
[Adjustment Purpose]
To adjust the link of the A-ch and B-ch of the tape playback outputs.
To make the unit compatible with other tapes and units. If this
specification is not satisfied, the link will appear on the screen and
the screen will be disrupted, etc.
Mode Playback
Signal Alignment tape: SP color bar portion
Measurement point CH1: Video LINE OUT
CH2: CN261 pin 3 (RF SWP)
Measuring instrument Oscilloscope
6.5 ± 0.5H (410 ± 32 µsec)
Specified value
[Adjustment Method]
1) Short-circuit between JS161 and ground for about 1 second to
activate the RF switching position adjustment mode.
2) Check that "AP" is indicated on FL display.
Using the channel + and – buttons, adjust to 410 ± 32 µsec (6.5
3)
± 0.5H).
4) Press the PAUSE button. (Adjustment is over for mono models.)
5) The set goes to the AF switching position adjustment mode.
CH1
CH2
Enlarrgement
CH1
6.5 ± 0.5H
CH2
CN261 pin 3
Fig. 6-2-3.
(RF switching position)
CN341 pin 1 (HF ADJ)
(AF switching position)
Approx.
1Vp-p
Approx.
5Vp-p
V
Vertical sync. signal
6) Check that "AH" is indicated on FL display.
7) Using the channel + and – buttons, minimize a chipped portion.
At this time, confirm that a noisy sound is not heard.
8) Press the PAUSE button.
9) Check that "AH" indication is disappeared. When it is not
disappeared, repeat from the item 1).
10) Press the STOP button.
11) Press the EJECT button.
CH2
RF SWP
CN261 pin 3
OK
CH1
REC AFM
CN341
pin 1
NG
Should be minimized
6-3
RF signal dropout
Fig. 6-2-4.