Bottom View - Sanyo PLV-Z3000 Service Manual

Clean by using the Cleaning function in the Setting Menu
1
Turn the projector on and press the MENU button to display the
On-Screen Menu. Select the Setting Menu with the Point
buttons. Press the Point
items.
2
Select Cleaning and then press the OK or Point
screen is blacked out temporarily.
3
Turn the projector over. Put your finger on hole over's tab and
pull to open the hole cover.
4
Put the blower's nozzle into a hole.
5
Blow air into the projector with the blower watching the position
of the dust from the screen.
6
When cleaning is done, pull the blower out of the hole and
replace the hole cover.
7
Set the projector back into the right position, then press any
button on the top control or on remote control to quit the
Cleaning function.
* Do not open the hole cover except when you clean the inside of the
projector to prevent foreign matters from getting into the projector.
If it is open especially while operating the projector, the optical parts
could damage.
Which hole to put the nozzle in?
When you look at the screen:
When a red spot (dust) is showed up, put the nozzle into the R
●
panel cleaning holes.
When a green spot (dust) is showed up, put the nozzle into
●
the G panel cleaning holes.
When a blue spot (dust) is showed up, put the nozzle into the
●
B panel cleaning holes.
B
R
G
Wave the nozzle back and forth inside of the projector.
(Do not attempt to bend the nozzle.)
Use only the supplied blower and nozzle.
Do not use a commercially available compressed
air duster. It causes the interior of the projector to
malfunction with release of cold liquid propellant. We could
not guarantee the malfunction of breakage by using other
tools.
or OK buttons to access the submenu
8
buttons. The
8
B
R
G
Blue
Cleaning
ed
LCd Panel
Green

BottoM VIEW

- 9 -
Maintenance and Cleaning
Select Cleaning in the
Setting Menu.
Tab
Put your finger on the
hole cover's tab and
pull.
Hole cover
The nozzle will go no
further than a certain
point when it is put
into the hole. Do not
attempt to push the
nozzle further in, or
it could break and be
stuck inside of the
projector.
Red
LCd Panel