Napa 6-1012 Instruction Manual page 2

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION
MANUAL CAREFULLY
AND UNDERSTAND ALL
INFORMATION
OPERATING THIS TOOL.
• Always operate, inspect and maintain
this tool in accordance with American
National Standards Institute Safety
Code of Portable Air Tools
and any other applicable safety codes
and regulations.
• For safety, top performance and
maximum durability of
parts, operate this tool
at 90 psig 6.2 bar max
air pressure with 3/8"
diameter air supply hose.
• Always wear impact-resistant eye and
face protection when operating or
performing maintenance
on this tool. Always wear
hearing protection when
using this tool.
• High sound levels can cause
permanent hearing loss.
Use hearing protection
as recommended
by your employer or
OSHA regulation.
• Keep the tool in efficient
operating condition.
• Operators and maintenance personnel
must be physically able to handle the
bulk, weight and power of this tool.
2 PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
L
WARNING!
!
• Air under pressure can cause severe
injury. Never direct air at yourself or
BEFORE
adjusting any accessory on this tool,
or before performing any maintenance
(ANSI B186.1)
or loose hoses and fittings, and replace
• Air powered tools can vibrate in
use. Vibration, repetitive motions or
uncomfortable positions over extended
medical advice before resuming use.
• Place the tool on the work before
starting the tool. Do not point or
indulge in any horseplay with this tool.
• Slipping, tripping and/or falling
• Keep body working stance
balanced and firm. Do not overreach
when operating the tool.
• Anticipate and be alert for sudden
changes in motion during start up and
operation of any power tool.
others. Always turn off the
air supply, drain hose of
air pressure and detach
tool from air supply before
installing, removing or
on this tool. Failure to do
so could result in injury.
Whip hoses can cause
serious injury. Always
check for damaged, frayed
immediately. Do not use
quick detach couplings at
tool. See instructions for
correct set-up.
periods of time may be
harmful to your hands and
arms. Discontinue use of
tool if discomfort, tingling
feeling or pain occurs. Seek
while operating air tools can
be a major cause of serious
injury or death. Be aware
of excess hose left on the
walking or work surface.
• Do not carry tool by
the hose. Protect the
hose from sharp objects
and heat.
• Tool shaft may continue to rotate
briefly after throttle is released. Avoid
direct contact with accessories during
and after use. Gloves will reduce the
risk of cuts or burns.
• Keep away from rotating end of tool.
Do not wear jewelry or
loose clothing. Secure
long hair. Scalping can
occur if hair is not kept
away from tool and
accessories. Choking can
occur if neckwear is not kept away
from tool and accessories.
• Never use a chisel as a handstruck
tool. They are designed and heat
treated to be used only in air ham-
mers. Select the correct shank and
retainer for the tool.
• Never use dull accessories. Never cool
a hot accessory in water as brittleness
and early failure can result. Accessory
breakage or tool damage may result
from prying. Take smaller bites to
avoid getting stuck.
• Do not lubricate tools with
flammable or volatile liquids such
as kerosene, diesel or jet fuel.
• Don't force tool beyond its rated
capacity.
• Do not remove any labels. Replace
any damaged labels.
• Use accessories recommended by
NAPA Professional Air Tools.
Rev. 5/29/02