Asus Crossblade Ranger User Manual page 95

OnChip SATA Channel [Enabled]
Enables or disables onboard channel SATA port. Configuration options: [Disabled] [Enabled]
OnChip SATA Type [AHCI]
Allows you to set the SATA configuration.
[IDE] Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[RAID] Set to [RAID] when you want to create a RAID configuration from the SATA
hard disk drives.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
SATA Port 5, 6, 7, 8 [AHCI]
This item only appears when OnChip SATA Type is set to [AHCI]. If SATA ports 5,
6, 7 and 8 are configured as [AHCI], the ports can only be used under OS with driver
installed. Set to [IDE] instead of [AHCI] to access devices on SATA ports 5, 6, 7 and 8
before entering OS. Configuration options: [AHCI] [IDE]
OnChip SATA MAX Speed [SATA 6.0Gb/s]
For better HDD compatibility, set the SATA speed to [SATA 3.0Gb/s] to support SATA
3.0Gb/s HDDs or [SATA 6.0Gb/s] to support SATA 6.0Gb/s HDDs. Configuration options:
[SATA 6.0Gb/s] [SATA 3.0Gb/s]
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Configuration options: [Disabled] [Enabled]
SATA ESP on Port1~8 [Disabled]
Enable this item to support ESATA. Configuration options: [Enabled] [Disabled]
SATA6G_1 (Red) - SATA6G_8 (Red)
Press <Enter> to rename the AMD SATA ports.
ASUS CROSSBLADE RANGER
3-21