Advertisement
RECEIVER BASE (RECEIVER)
RECEIVER BASE (RECEIVER)
7
Microphone Storage Dock
11
8
9
Power Switch
Power and Signal Indicator
Microphone storage dock -
7
The Microphone docking opening allows for the convenient
storage of the microphone in the base when the microphone is not
in use.
Power switch -
8
Pressing the power switch turns the receiver base on or off.
Power and signal indicator -
9
Once the receiver base is powered on, the LED will illuminate red.
Once the handheld microphone is turned on, the green LEDs on
both the handheld microphone and the receiver base will flash in
sequence indicating the two devices are communicating. The red
LED will illuminate when the receiver base's batteries need
replacement. A constant weak red LED indicates that the base's
batteries are low and in need of replacement. The red LED will not
illuminate if the base is powered by the AC power adaptor.
Battery compartment cover -
10
To open the battery compartment on the receiver base, gently
press the "D" shaped tab on the compartment cover toward the
compartment and then gently lift the compartment cover off. The
receiver base operates on (2) AAA alkaline batteries. Optionally,
the base may be powered from an AC adaptor (see 12)
Audio output -
Your V2GO Dyna-Mic has been supplied with an audio connection
cable. The small end of the cable connects to the receiver base as
shown. Note that the connector has a polarization tab that must
align with the slot in the receiver base's connector. To remove,
depress the small black button and gently pull the connector out.
The other end of the supplied audio cable (standard TR ¼" audio
connector) connects to any ¼" microphone input on your PA
System, karaoke player, audio mixer or stereo system.
AC adapter jack -
For use with the 9VDC, 160mA, AC adaptor. When the AC adaptor
is used, the receiver base's batteries will be internally
disconnected.
(Note:
(Note: The use of the AC adaptor will not recharge batteries
installed in the receiver base. Insert the end of the AC adaptor's
power cable firmly into the AC power connector.)
12
Ac Adapter Jack
Audio Output
10
Battery Compartment Cover
SETUP ILLUSTRATION
SETUP INSTRUCTION
Batteries are installed
AC Adaptor is connected
Or batteries are installed
1. Insert batteries in handheld microphone. See 6
2. Insert batteries in receiver base. See 10
3. Connect AC adaptor, then plug the AC adaptor into a power outlet.
See 12
4. Connect supplied cable between the Dyna-Mic.01 and your audio
system. See 11
5. Depress the power button on the receiver base. See 9
6. Switch the power switch on the handheld microphone to the ON
position. See 4
7. Set audio level (microphone input level) initially to the ½ way
position on the attached karaoke player, audio mixer or PA
system.
8. With the audio system that the Dyna-Mic.01 is connected to
powered on and operating, switch the handheld microphone's
mute switch to the UP (un-muted) position.
9. Speak into the microphone to verify operation and to adjust the
microphone's sound level on the attached karaoke player, audio
mixer or PA system.
2
AC110V
/AC220V
Amplifier
PA System
Audio Mixer
Illuminating green signal indicator
Power switch is on the right
Mute switch is up
Hook up with audio system
Illuminating green
Press once to power on
Advertisement
