Fat Cat 42-1012 Easy Assembly Instructions & Rules page 3

Power Installation
The dartboard is designed to be powered by an AC to 9V DC, 800 milliamp (minimum)
adapter, with the DC plug polarity configured as positive (+) outside, and negative (-) center.
To connect by adapter, plug the DC plug into the DC power jack and the AC plug into an
electrical outlet.
Use of Transformer:
1. The board is not intended for children under the age of 3 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect from transformer before cleaning.
Protective Film
This electronic dartboard has a clear protective film over the entire display area and button
area to prevent scratching during shipping. Remove this film for easier reading of the display.
To remove, simply lift edge, peel off and discard.
Wall Stud Marking for Mounting Screw
5 1 / "
2
(14 cm)
68"
(173 cm)
Floor
Mounting
75 5
(192 cm)
Throwing
or Toe Line
3
Throwing Distance
/ "
8
Floor
96"
(244 cm)
Center of Board
68"
(173 cm)
Plumb Line
from Face
of Board
to Floor
Wall