Advertisement
Step 9 - Adjusting Shock Sensitivity
You can program the shock sensitivity level of your First Defense
maximize sensitivity while reducing false alarms.
TO ENTER PROGRAMMING MODE:
1) Press button #3 for 10 seconds and then let go of the button only
after you have seen the confirmation light flashes or you will not enter
the programming mode! Once you have seen the confirmation light
flashes, you are ready to program your shock sensitivity.
2) By pressing button #1(GREEN) button
again you can scroll through the different
levels of shock. There are 8 levels of shock
and 8 corresponding tones. The higher the
number of flashes, the more sensitive the
alarm is to shock. Remember, you are
simulating the shock which the car would
feel if someone were tampering with your
vehicle). Be very careful when using level
7 or 8 as these are the most sensitve levels
of shock protection and this may cause your
unit to false alarm due to loud noises or
minor vibrations produced by large trucks
passing by, heavy machinery or heavy rain
and thunder.
3) When you have settled on a proper sensitivity level, simply press
button #2 (RED) to exit programming mode and save this sensitivity
level. If you don't press any buttons for 5 seconds, you will
automatically exit the programming mode with the setting of the last
number of flashes.
Page 10
to
®
Press button 3 for a 10
seconds, to enter
programming mode
20630 / 20930
Step 10 - Choosing A Siren Tone
You can personalize your alarm's sound by selecting one of eight
different siren sounds.
TO ENTER PROGRAMMING MODE:
1) Press button #1 for 10 seconds and then
let go of the button only after you have heard
the siren sound.
2) By pressing the GREEN button #1 in the
siren sound selection mode, you can scroll
through the various siren sounds until you find
one you like (you will hear 2 seconds of the
selected siren sound each time you scroll to a
sound).
3) When you have settled on a favorite sound,
simply press button #2 (RED) to exit
programming mode and save the last sound
played. If you don't press any buttons for 5
seconds, you will automatically exit the
programming mode.
20630 / 20930
Press button 1 for a
10 seconds, to
enter programming
mode
Page 11
Advertisement
