Fujitsu fi-6800 Consumable Replacement And Cleaning Instructions page 22

fi-6800 C R
ONSUMABLE EPLACEMENT AND
22
C I
LEANING NSTRUCTIONS
C G A
LEANING THE LASS REAS
• Clean the Glass Areas on the lower side of the ADF with a lint free
cloth.
Removable Glass
Non-Removable Glass
Note:
Under normal conditions the Removable Glass assembly should not
have to be removed. If there is a large amount of paper dust in the
scanner and the scanned images continue to have vertical streaks,
follow the directions below to clean behind the glass.
• Loosen the screw on the Glass
Assembly. This is a captive
screw so it will not come free.
• Tilt the Glass to the angle shown
on the right.
• Remove the Glass as you slide it
to the left.
• Clean the backside of the glass
you removed with a lint free
cloth.
• Using a cotton swab, clean the
glass inside the area where the
Glass was removed.
• Reinstall the Glass Assembly.
• Reset the Cleaning Counter in the Software Operation Panel or on the
Scanner Operator Panel.
( .)
CONT
Glass