Kia 2007 Magentis Owner's Manual page 89

Ofrecido por www.electromanuales.com
Knowing your vehicle
Programming HomeLink®
• When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink® for quicker
training and accurate transmission
of the radio-frequency signal.
• Some vehicles may require the igni-
tion switch to be turned to the sec-
ond (or "accessories") position for
programming and/or operation of
HomeLink.
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below,
HomeLink® at: www.homelink.com
or 1-800-355-3515.
3 80
Standard programming
To train most devices, follow these
instructions:
1. For first-time programming, press and
hold the two
HomeLink® Channel 1 and Channel 3
Buttons, until the indicator light begins
to flash (after 20 seconds). Release
both buttons. Do not hold the buttons
for longer than 30 seconds.
2. Position the end of your hand-held
transmitter 5-14 cm (1-3 inches) away
from the HomeLink® buttons while
keeping the indicator light in view.
3. Simultaneously press and hold both
the HomeLink® and hand-held trans-
mitter button. DO NOT release the but-
tons until step 4 has been completed.
contact
4. While continuing to hold the buttons
the red Indicator Status LED will flash
slowly and then
HomeLink® successfully trains to the
frequency signal from the hand-held
transmitter. Release both buttons.
5. Press and hold the just-trained
HomeLink® button and observe the
red Status Indicator LED. If the indica-
tor light stays on constantly, program-
ming is complete and your device
outside buttons,
should activate when the HomeLink®
button is pressed and released.
6. To program
HomeLink® buttons, follow steps 2
through 5.
rapidly after
the remaining two