Transmitter Operation - Martin DC2500e Instruction Manual

THE BATTERY:
Pry transmitter apart using a small coin to expose battery. The 3 Volt #CR2032 battery is
shown. Battery life can last 4 to 5 years. See Figure 36.
TRANSMITTER MOUNTING CHOICES:
Transmitter can be carried alone, attached to a key chain, attached to the visor clip or
attached using the optional mounting plate. See Figures 36, 37, 38.
MULTIPLE TRANSMITTERS:
Each transmitter has been factory programmed with different private security codes. For
your information there are 284 trillion different codes. 2-channel transmitters have 2
different codes. 4-channel transmitters have 4 different codes. Additional transmitters
that come with the opener or are purchased separately as accessories have their own
different codes that must be changed to match your first transmitter.
Connect the programming tine to both transmitters. See Figures 38, 39, 39A and 39B.
Press and hold button on your present transmitter. Indicator light will blink. See Figure
39A. While still holding the 1st transmitter button, press and hold the button on the new or
second transmitter. Code transfer will occur in approximately 2 seconds when the indicator
light on the new transmitter illuminates continuously. See Figure 39B
The 315 mhz transmitters are "Home Link" compatible. Follow instructions furnished in the
automobile owners manual for non-rolling code applications.

TRANSMITTER OPERATION:

Press button until garage door begins to move. The indicator light on the transmitter will
be blinking. Press button at any time during travel to stop the garage door. See Figure 40
FIGURE 39
PRESENT NEW OR SECOND
TRANSMITTER TRANSMITTER
INDICATOR
LIGHT
PROGRAMMING
TINE
FCC Certified: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
COPYRIGHT © 2003 MARTIN DOOR
STEP 15
TRANSMITTERS
FIGURE 39A
PRESENT NEW OR SECOND
TRANSMITTER TRANSMITTER
MARTIN MARTIN
PROGRAMMING
TINE
FIGURE 39B
PRESENT NEW OR SECOND
TRANSMITTER TRANSMITTER
MARTIN MARTIN INDICATOR
LIGHT
PROGRAMMING
TINE
FIGURE 36
COIN
FIGURE 37
SNAP VISOR CLIP INTO SOCKET
VISOR CLIP COVER
(REMOVE SMALL
COVER TO EXPOSE
VISOR CLIP SOCKET)
VISOR CLIP SOCKET
MINI
TRANSMITTER
FIGURE 38
3 BUTTON MICRO
TRANSMITTER
(OPTIONAL)
PROGRAMMING
TINE
TRANSMITTER
MARTIN
MINI TRANSMITTER
BACK
CIRCUIT BOARD
BATTERY
(#CR2032)
MINI TRANSMITTER
FRONT
M
A
R T
I
N
MINI
TRANSMITTER
SCREW
MOUNTING PLATE
(OPTIONAL MAY BE USED AS )
A WALL CONTROL ETC.
4 BUTTON MINI
TRANSMITTER
(OPTIONAL)
FIGURE 40
17