Table of Contents
Advertisement
5
Press the display operation 2 [Enter] key.
4
• The source selecting display appears.
• When you select "Phono" in step 4, go to step 0.
>05.VCR
>06.Cable
Back Enter
6
Press the 5 / ∞ keys to select the source you want to
register.
• Each time you press the 5/∞ key, the input changes as follows:
01:
CD
02:
Tape
03:
MD
04:
CD-R
05:
VCR
06:
Cable
07:
Satellit
08:
TV
09:
LD
10:
DVD
11:
DSS (U.S.A only)
12:
No type
13:
Delete
• Select "No type" when the desired source does not appear in the
display.
• The selected input does not appears when you select "Delete."
7
Press the display operation 2 [Enter] key.
• The maker selecting display appears.
For Europe and U.K
>Kenwood
>Aiwa
Back Enter
8
Press the 5 / ∞ keys to select the maker you want to
register.
• Press the 5/∞ keys until the desired maker appears in the display.
When the desired maker does not appear, select "Nothing."
9
Press the display operation 2 [Enter] key.
• The setup code selecting display appears.
>01:0056
>02:Nothing
Back Enter
0
Press the 5 / ∞ keys to select the setup code.
!
Press the AV.POWER
component you want to control turns on.
If the component does not react, and there is more than one
setup code, enter another setup code and try again.
• ‹ or TUNING key can also be used instead of the AV. POWER
key.
• If the component is already on, pressing the AV. POWER
will turn it off.
For other countries
>Kenwood
>Admidral
Back Enter
key, and check to see that the
@
Press the display operation 2 [Enter] key.
• The display returns to the setup display.
>01.IR
>02.Surround
Home Enter
Repeat steps 3 to @ to register additional components
until all components have been registered.
To returns to the initial display, press [Back] repeat-
edly until " Menu " appears in the display.
Video1:
VCR
Menu
• Once registered, the display on the receiver shows the component
type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 jacks, "Video1" and
"VCR" appear in the display.
• Any VIDEO or TV (TV1, TV2, CABLE) inputs that have not been
programmed with a setup code or Non-IR code are deleted from the
cyclic list.
When you mistake
Press the display operation 1 [Back] key repeatedly until the display
you want to re-operate appears.
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models. (Also, certain
codes may only operate some of the functions available on a given
model.)
key
Getting the most from your remote control
Advertisement
Table of Contents
