Table of Contents
Advertisement
Register the setup codes for your audio and video components
2
Step 1
Press the display operation 1 key re-
Video1:
peatedly until "Menu" appears in the dis-
VCR
play.
Menu
For step 1 through step 9, make sure you
start the next step within 8 seconds of
completing the previous one. If more than
8 seconds elapses between any two steps,
press the display operation key so that
the display appears.
Step 2
Press the display operation 2 [Menu]
key repeatedly until "01.IR" appears in
>01.IR
the display.
>02.Surround
Home Enter
Step 3
Press the
then press the display operation 2
>01.IR
[Enter] key.
>02.Surround
Back Enter
Step 4
Press the
that you want to register, then press the
>03.Video1
display operation 2 [Enter] key.
>04.Video2
Back Enter
Step 5
Press the
ponent that you want to register, then
>05.VCR
press the display operation 2 [Enter]
>06.Cable
key.
Back Enter
Step 6
Press the
of the component that you want to reg-
>Kenwood
ister, then press the display operation
>Aiwa
2 [Enter] key.
Back Enter
Automatic input naming
In the initial factory setting, the remote control already has provisional component names registered for each input. Before you register setup codes, pressing
the input keys of the remote control causes the display to change from the factory preset input names of the receiver (VIDEO1, VIDEO2, etc.) to the input
names registered in the remote control (VCR1, VCR2, etc.). Once you have registered the appropriate setup codes for your components, pressing the input
keys of the remote control causes the display to change to the actually connected component names (LD, DVD, etc.) for which you have registered setup
codes.
5/∞
keys to select "01.IR",
5/∞
keys to select the input
5/∞
keys to select the com-
5/∞
keys to select the maker
Step 7
5/∞
Press the
code.
>01:0056
>02:Nothing
Back Enter
Step 8
Press the AV.POWER
AV.POWER
you can turn the component on and off.
If your component has a mechanical
POWER switch that cannot be operated
by remote control unit, press the dis-
play operation 2 [Enter] key and dis-
play operation 1 [Home] key, and se-
lect the component by pressing the
MUSIC, MOVIE, or TV key, then press
the PLAY (‹) key or TUNING (2 3) key
to test it.
If the component does not respond when you try to
control it, return to step 7 and enter the next setup
code on the list. Repeat this procedure until you find
the code that matches the component. When the
component does not respond, select "Nothing."
Step 9
Press the display operation 2 [Enter]
key to store the code.
>01.IR
>02.Surround
Home Enter
Repeat steps 3 through 9 to enter the codes for each
component you want to control.
Press the display operation 1 key repeatedly until "Menu"
appears in the display.
If you accidentally exit the registration mode by pressing the
wrong key, you will not lose any setup codes you have
already saved.
keys to select the setup
key to see if
Advertisement
Table of Contents
