Hunter ceiling fan Owner's Manual page 16

Operation, Maintenance, & Cleaning
Battery
Door
Phillips
Head
Screw
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. The battery
should be installed with the positive
(+) side up. Replace with a CR2032
battery when necessary.
Turn Power
ON
Fan Off
High
Note: The remote must be paired
before the fan will operate.
Within 3 minutes of restoring power
to the fan, press both the Fan Off
button and the High button for at
least 4 seconds. Your fan will turn on
low to indicate successful syncing.
If it does not, turn off power to your
fan, wait 1 minute then try again. If
using the transmitter with multiple
fans, repeat this process for each fan.
M3521-01 • 05/14/14 • © Hunter Fan Company
Medium
Speed
Fan
Off
Speed
Low
Light
Speed
To turn on fan, press a fan speed
button. Speeds range from off (0)
to high (3). Quickly press the Light
button to turn the lights off and on.
Hold the Light button to raise and
dim the light level.
16
www.HunterFan.com
High
Removed
Tabs
To install the transmitter cradle, remove
the two screws holding the switch
cover plate. Do not remove the cover
plate. Orient the cradle by lining up
the two mounting holes with those on
the cover plate. Insert and tighten the
screws. Do not over tighten.
Note: For rocker-style cover plates,
break off the tabs by pushing outward.
1.888.830.1326
Switch Cover
Plate
Rocker- Style
Plate