Kobalt K20-MC60A User Manual page 13

OPERATinG inSTRuCTiOnS
1. Charge the battery pack with the correct charger.
2. Connect the charger to a power supply.
3. Attach the battery pack to the charger by aligning the raised
ribs of the battery pack with the slot in the charger. Slide the
battery pack onto the charger (Fig. 1).
4. The charger will communicate with the battery pack's circuitry
to evaluate the condition of the battery pack. Please see
ChARGER DiSPLAY on the following pages.
5. If defective, remove and re-insert the battery pack in the
charger. If the screen indicates "defective" a second time, try
charging a different battery pack.
6. If a different battery pack charges normally, dispose of the
defective battery pack.
7. If a different battery pack also indicates "defective," the
charger may be defective.
nOTiCE: The battery pack will fully charge, but will not overcharge,
if left on the charger.
nOTiCE: The charger may warm with several continuous charge
cycles. This is part of the normal operation of the charger. Always
charge in a well-ventilated area.
13