Advertisement
Quick Links
Advertisement
Related Manuals for OWI CRS201
Summary of Contents for OWI CRS201
- Page 1 CRS201 INFRARED W ELESS MICROPHONE SYSTEM INSTALLATION INSTRUCTIONS...
- Page 2 This package contains the ff: - 1 each ..CRS-201-CASE- MIXER/AMPLIFIER - 2 each ..CRS-IRS - IR SENSORS - 1 each ..CRS-PMIC - PENDANT MICROPHONE - 1 each .
-
Page 3: Safety Instructions
SAFETY INSTRUCTIONS Read all of these instructions before operating and save instructions for later use. Read Instructions – All the safety and operating instructions should be read before the appliance is operated. Retain Instructions – The safety and operating instructions should be retained for future reference. Heed Warnings –... - Page 4 Headset Microphones, so they will never get misplaced. The CRS-201 when combined with OWI’s P5278 Bookshelf or IC5 or IC6 in-ceiling speakers help create professional easy to hear presentations of both spoken content and audio from external sources such as CD/DVD players, Computers, Cable, Satellite, VCR, etc.
- Page 5 4. WIRE ACCESS – Space in the CRS-201-CASE cabinet allows connection to an external audio source and two wired microphones, with the door closed. 5. KNOCKOUTS – Three knockouts. Additional wire access on the side of the CRS201. 6. POWER CORD INPUT – connects to the female end of the power cord.
- Page 6 Figure 3. CRS-201-CASE Front Panel (Door Open) CRS-201-CASE FRONT PANEL FEATURES The CRS-201-CASE Front Panel features all of the controls for the CRS-201 System. POWER SWITCH – One, two position toggle switch turns the power mains to the CRS-201- CASE ON/OFF. STORAGE SPACE –...
- Page 7 Figure 4. CRS-201-CASE Inside Panel CRS-201-CASE INSIDE PANEL FEATURES An external audio source such as a CD/DVD Player, computer, projector, cable, satellite, etc and standard unbalanced, low impedance wired microphones can be connected to the Inside Panel. 15. LINE IN – Two, RCA Jacks connect to the L & R line-level audio outputs on a stereo audio source.
- Page 8 CRS-201-CASE TOP PANEL FEATURES The IR Sensors and Speakers get connected to the Side Panel 19. SPEAKER TERMINALS – Two pair, five-way binding posts, connect to classroom speakers. (OWI Models P5278, IC5 or IC6 suggested.)NOTE: Both speakers output the same audio signal, (mono).
- Page 9 Figure 7. CRS-IRS IR Sensor CRS-IRS IR SENSOR FEATURES 24. MINI PLUG – One, 3.5mm mini plug connects to one of the three IR Sensor Jacks on the CRS-201- CASE Side Panel. 25. CABLE – 50’ cable allows the IR Sensors to be positioned away from the CRS-201-CASE for optimum coverage for reception of IR pulses from the CRS IR Microphones.
- Page 10 NOTE: THE PENDANT IS ALSO A CHARGER. DO NOT CONNECT THE CHARGER POWER SUPPLY WHEN USING NON-RECHARGEABLE BATTERIES! 31. IR OUTPUT ARRAY – High output IR LED’s output audio as infrared pulses in an omni-directional pattern that are received by the CRS-IRS IR Sensors. The IR Sensors output electrical DC pulses to the CRS-201-CASE which converts them back to audio signals, amplifies them and outputs the audio to the Speakers.
- Page 11 Figure 10. CRS-HSMIC Headset Mic (Optional) CRS-HSMIC HEADSET MIC FEATURES (Optional) The CRS-HSMIC Lapel Microphone is used with the Pendant Mic and is another option for hands-free presentations. NOTE: The CRS-HSMIC is an optional accessory and must be purchased separate from the CRS-201. 39.
- Page 12 Figure 11. CRS-HHMIC2 Hand Held Microphone (Optional) CRS-HHMIC2 HAND HELD MICROPHONE FEATURES (Optional) The HHMIC2 Hand Held Microphone is an optional accessory that can be used for presentations or can be passed around the room for Q&A so everyone in the room can clearly hear questions from the class or audience.
-
Page 13: Installation
Figure 12. Typical Classroom Application INSTALLATION CRS-201-CASE The CRS-201-CASE can be wall or shelf mounted. It should be located in a central location that allows the IR Sensors to be equally spread in the classroom for optimum visibility to the microphones. Consideration should also be given to locating the CRS-201-CASE in close proximity to any audio source that will be connected to the Line In, such as a CD/DVD Player, Projector, Computer, VCR, Cable, Satellite, etc. - Page 14 HOW TO MOUNT THE CRS201 USING THE MOUNTING PLATE...
- Page 15 Horizontal Mounting Vertical Mounting Figure 13. IR Sensor Wall Mount Adaptor CRS-IRS IR SENSORS The CRS Microphones output IR Pulses that are invisible light pulses. Ideally, the IR Sensors should be ‘line-of-sight’ to the microphones. The microphones output very strong IR pulses that will reflect off wall, ceiling and hard floor surfaces and are then ‘seen’...
- Page 16 Figure 14. Typical CRS System Connections CONNECTIONS The CRS-201 System requires only a few simple connections and sets up in minutes. The only required connections are the IR Sensors, Speakers and Power Cord. Connecting an optional audio source such as a CD/DVD Player, VCR, Computer, Projector, Cable, Satellite, etc is also simple using standard RCA- RCA audio patch cables.
- Page 17 Line In 1. Connect the left and right line level audio outputs of an audio source to the L and R Inputs on the CRS-201-CASE using a stereo RCA-RCA patch cable with gold ends. NOTE: Though the CRS has Left and Right Inputs, the Speaker Outputs are mono, so BOTH channels will be output from BOTH speakers.
-
Page 18: Operation
OPERATION 1. IF TURNING THE SYSTEM ON FOR THE FIRST TIME, turn the VOL Knobs all the way down (full counterclockwise). 2. With all system connections confirmed, press the Power Switch to turn the system ON. 3. If using the Lapel or Headset Mic, connect to the Pendant as shown in Figure 16. Be sure the Pendant is pointing toward the IR Sensors so the IR Pulses from the Pendant will be ‘seen’... - Page 19 Figure 16. Using the Lapel Mic and Pendant RESET FUSE REPLACEMENT The fuse compartment is located within the power cord input on the left side of the CRS201 case. You will need a small flat screw driver to pry up the fuse case.
-
Page 20: Specifications
SPECIFICATIONS CRS-201-CASE MIXER/AMPLIFIER IR Carrier Frequency 2.06MHz and 2.56MHz Deviation Range ± 40kHz Input Sensitivity LINE 150mV TV/DVD (Unbalanced Line Mono) 150mV COMP (Unbalanced Line Mono) 150mV Signal to Noise ≥70dB LINE ≥70dB TV/DVD (Unbalanced Line Mono) ≥70dB COMP (Unbalanced Line Mono) ≥100dB WIRELESS MIC <0.5% @ 1KHz... - Page 21 CRS-PMIC PENDANT MICROPHONE Polar Pattern Unidirectional Electret Condenser Microphone IR Carrier Frequency 2.06MHz or 2.56MHz Battery 3.7V 800MAh AA Lithium Dimensions H x W x D 4.7 x 1.3 x 0.7 inches (120 x 34 x 18 mm) Weight (with battery) 0.13lbs (.57kg) CRS-PENCH PENDANT CHARGER Input Voltage...
- Page 22 Battery Current/Life 0.1mA @ 5V Voltage 2.5-11V DC Cable Length 40 inches (1.016m) Weight 0.04 lbs (0.02kg) Dimensions Headset 6.1 inches (155 mm) Microphone 0.20 inches (5.1 mm) Body 6.7 inches (170 mm) Accessory HM-008 Windscreen CRS-HHMIC2 HANDHELD MICROPHONE Polar Pattern Uni-directional Dynamic Carrier Frequency 2.06MHz and 2.56MHz...
- Page 23 17141 Kingsview Avenue Carson, CA 90746-1207 Telephone: 310.515.1900 Fax: 310.515.1606 Web: www.owi-inc.com ©2008 OWI Incorporated...