Advertisement
Quick Links
Advertisement
Related Manuals for OWI CRS301-P
Summary of Contents for OWI CRS301-P
- Page 1 CRS301 INFRARED W ELESS MICROPHONE SYSTEM INSTALLATION INSTRUCTIONS...
- Page 2 This package contains the ff: A - 1 each ..CRS-301-CASE- MIXER/AMPLIFIER B - 2 each ..CRS-IRS - IR SENSORS C - 1 each ..CRS-PMIC - PENDANT MICROPHONE D - 1 each .
-
Page 3: Safety Instructions
SAFETY INSTRUCTIONS Read all of these instructions before operating and save instructions for later use. Read Instructions – All the safety and operating instructions should be read before the appliance is operated. Retain Instructions – The safety and operating instructions should be retained for future reference. Heed Warnings –... - Page 4 When not in use, the CRS-301-CASE provides a secure, locking door to prevent touching The CRS-301 when combined with OWI’s P5278 Bookshelf or IC5 or IC6 in-ceiling speakers help create professional easy to hear presentations of both spoken content and audio from external sources such as CD/DVD players, Computers, Cable, Satellite, VCR, etc.
- Page 5 CRS-301-CASE Features Figure 1. CRS-301-CASE Front View - Door Closed Figure 2. CRS-301-CASE Back and Side Views CRS-301-CASE CABINET FEATURES 1. DOOR LOCK – Locks the CRS-301-CASE Door to keep unauthorized fingers off the system controls and settings. 2. MOUNTING PLATE – Holds the CRS-301-CASE securely on the wall. 3.
- Page 6 Figure 4. CRS-301-CASE Inside Panel CRS-301-CASE INSIDE PANEL FEATURES An external audio source such as a CD/DVD Player, computer, projector, cable, satellite, etc and standard unbalanced, low impedance wired microphones can be connected to the Inside Panel. 15. 3.5 Mini Jack LINE IN – 3.5 Stereo Mini Jack input NOTE: The CRS will output BOTH channels to BOTH Speakers (mono).
- Page 7 Gain/level control for K Balanced Line Level output Gain/level control for L CAT5 output to OWI AMP Speakers only Speakers Strip approximately ¼” off each lead and twist the ends so there are no loose strands that can cause shorts. The recommended speaker wire size is 14 to 16 gauge.
- Page 8 19. Microphone A control – Main Volume for the microphone A 20. IR SENSOR JACKS – Three, 3.5mm mini jacks connect to the CRS-IRS IR Sensors for input of IR pulses (audio signals) from the Headset, Lapel, Pendant or Handheld Microphones. Use any two of the three inputs with the included IR Sensors 21.
- Page 9 CRS-LMIC LAPEL MIC FEATURES - The CRS-LMIC Lapel Microphone is used with the Pendant Mic for inconspicuous hands-free presentations. MICROPHONE – Detects audible sound such as voice. Should be positioned as close to the speaker’s mouth as possible. LAPEL CLIP – Attaches the Lapel Microphone to a jacket lapel, shirt or blouse. MINI PLUG - Connects to the MIC Input on the CRS-PMIC Pendant.
-
Page 10: Installation
NOTE: The CRS-HHMCS Charger is also an optional accessory and is purchased separate from both the CRS-301 and CRS-HHMIC. Figure 12. Typical Classroom Application INSTALLATION CRS-301-CASE The CRS-301-CASE can be wall or shelf mounted. It should be located in a central location that allows the IR Sensors to be equally spread in the classroom for optimum visibility to the microphones. - Page 12 Horizontal Mounting Vertical Mounting Figure 13. IR Sensor Wall Mount Adaptor CRS-IRS IR SENSORS The CRS Microphones output IR Pulses that are invisible light pulses. Ideally, the IR Sensors should be ‘line-of- sight’ to the microphones. The microphones output very strong IR pulses that will reflect off wall, ceiling and hard floor surfaces and are then ‘seen’...
-
Page 13: Operation
OPERATION 1. IF TURNING THE SYSTEM ON FOR THE FIRST TIME, turn the VOL Knobs all the way down (full counterclockwise). 2. With all system connections confirmed, press the Power Switch to turn the system ON. 3. If using the Lapel or Headset Mic, connect to the Pendant as shown in Figure 16. Be sure the Pendant is pointing toward the IR Sensors so the IR Pulses from the Pendant will be ‘seen’... -
Page 14: Specifications
BATTERIES Be sure to charge the batteries before each use. Hand Held Microphone recharge time: approximately 4 hours. Pendant recharge time: approximately 3 hours. Figure 16. Using the Lapel Mic and Pendant SPECIFICATIONS CRS-301-CASE MIXER/AMPLIFIER IR Carrier Frequency 2.06MHz and 2.56MHz Deviation Range ±... - Page 15 Battery 3.7V 800MAh AA Lithium Dimensions H x W x D 4.7 x 1.3 x 0.7 inches (120 x 34 x 18 mm) Weight (with battery) 0.13lbs (.57kg) CRS-PENCH PENDANT CHARGER Input Voltage 110V AC / 60Hz Output Voltage 6V DC Output Current 1000mA CRS-LMIC LAPEL MICROPHONE...
- Page 16 17141 Kingsview Avenue Carson, CA 90746-1207 Telephone: 310.515.1900 Fax: 310.515.1606 Web: www.owi-inc.com ©2008 OWI Incorporated...