SUPPORT GUIDE FOR
USING THE NOKIA CARDPHONE 2.0 IN A
WINDOWS CE DEVICE
Copyright © Nokia Mobile Phones 2000. All rights reserved | Date: 06.03.01, ver. 1.0

   Related Manuals for Nokia Card phone

No related manuals

   Summary of Contents for Nokia Card phone

  • Page 1

    SUPPORT GUIDE FOR USING THE NOKIA CARDPHONE 2.0 IN A WINDOWS CE DEVICE Copyright © Nokia Mobile Phones 2000. All rights reserved | Date: 06.03.01, ver. 1.0...

  • Page 2: Table Of Contents

    Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.

  • Page 3: Introduction

    INTRODUCTION How to configure a Windows CE device to function using the Nokia Cardphone 2.0 phone as a modem To install and run NCP2, you need the following: • Nokia Cardphone 2.0 • A Windows CE device with ARM, SH3 or MIPS CPU and PC Card slot •...

  • Page 4: General Things About The Driver

    Phonebook and for SMS management. Power Up/Down feature Please note that if you want to save on the power consumed by the Nokia Cardphone 2.0 and to avoid EM radiation usage in some specific environment, you are advised to select the power down function located at the monitor or tray icon, or to remove the Nokia Cardphone 2.0 device manually from the PC card slot.

  • Page 5

    “Power”: To power up or down the Nokia Card Phone 2.0, select the power up function. The click mark indicates the power up status. You can also click “Automatic Power Up”; then the Nokia Card Phone 2.0 will power up automatically the next time it is inserted in the PC Card slot.

  • Page 6: Setting Up A New Connection

    5. SETTING UP A NEW CONNECTION Figure 2. Select a modem and Figure 3. Check Connection Figure 4. Type in the ISP's phone check the Baud Rate (either preferences number and then tap Next. 57600 or 115200). Tap OK on upper right corner and After that tap Advanced…...

  • Page 7

    Figure 5. Uncheck the Wait for Figure 6. Now go to Dialling leaflet[“screen”?] Figure 7. In some cases you may Dial tone before dialling check and go to Dialling Patterns… need to edit these to get the phone box and tap Finish. number right when dialling.

  • Page 8: Making A Dial-up Connection

    3. MAKING A DIAL-UP CONNECTION 1. Go to the Start menu and select Programs. 2. Select Connections. 3. You should now see the icons of the available connections; click on the connection you have just created (Figure 8). 4. Fill in your User name and Password and tap Connect (Figure 9). 5.

  • Page 9: Hanging Up The Connection

    3. Select Disconnect (Figure 12). Figure 12. 6. UNINSTALLATION Remove the Nokia Card Phone 2.0 device from the PC card slot. Go to “Control Panel”, choose “Remove Programs”. Remove “Nokia Card Phone 2.0 Version 1.11”. *) *) The version number may be different depending on what version of the software you have...

Comments to this Manuals

Symbols: 0
Latest comments: