Table of Contents
Advertisement
Quickstart
Note
The first time you connect a machine to a VCA by using a connection port, you
are prompted to install a driver. After the driver is successfully installed and the
machine is rebooted, you can configure VCA interfaces.
After you make changes to a section in the VCA Setup page, you must click
If you leave fields empty in a section, you must still click
to the next section.
You can configure all network settings from the VCA Setup page or a Linux shell.
To configure from the VCA Setup page, the hostname, and the static IP address or DHCP
address of all network interfaces of the VCA:
1 Change the IP address of the external machine to
2 Connect to the VCA Setup page:
2.1 Connect the external machine to the
tion) by using an Ethernet cable
2.2 Connect the
2.3 Connect a browser to
Note
For more information about changing various parameters, see
using the VCA
If your network has a DHCP server running, the
connected to it.
3 To change the network settings of an interface to a static IP address, use the network
parameter section of the Setup page:
3.1 Add a static IP address
3.2 Add a gateway
3.3 Add a network mask
If you are not sure what to enter, ask your system administrator.
Note
From this Setup page, you can switch an interface to a static IP address or to
DHCP as often as you want.
If you do not want to change the network settings of an interface to a static IP
address, leave this section empty and click
4 To test the performance of the Quadro VCA, perform a render test by clicking
5 After you have completed and submitted all sections, a
the upper left corner of the form. Click
interface to your local LAN.
eth3
http://192.168.124.10:14000
Manager".
Quadro VCA — Installation Guide
Submit
192.168.124.2
interface (marked in blue in the illustra-
eth2
eth3
.
Submit
Restart
to restart the VCA Manager.
Restart
Submit
before continuing
.
.
"System setup
interface is automatically
Start Test
button is displayed in
©
,
NVIDIA ARC GmbH
.
.
Advertisement
Table of Contents
