Specifications - Kenwood Sovereign MX-5000 User Manual

Specifications

Power amplifier section
Rated power output
STEREO MODE
130 watts per channel minimum RMS, both channels driven at 6 Ω, from 20 Hz to 20,000 Hz
with no more than 0.02 % total harmonic distortion (FTC)
MONO (BTL) MODE
270 watts minimum RMS, at 6 Ω, from 20 Hz to 20,000 Hz with no more than 0.03 % total
harmonic distortion (FTC)
Frequency response
MAIN IN .................................................................................... 5 Hz ~ 100 kHz, +0 dB, –3 dB
Signal to noise ratio
(IHF'66) MAIN IN ................................................................................. 115 dB
Input sensitivity / Impedance
STEREO MODE MAIN IN ......................................................................... 1.1 V/20 kΩ
MONO (BTL) MODE MAIN IN ....................................................................... 1.5 V/100 kΩ
General
Power consumption ............................................................................................................... 3.5 A
......................................................................................... Less than 2 W (Standby)
Dimensions
W: ................................................................................................... 440 mm (17-5/16")
H: ..................................................................................................... 128 mm (5-1/32")
D: ................................................................................................... 385 mm (15-5/32")
Weight (net ) ...................................................................................................... 12.3 kg (27.2 lb)
• KENWOOD follows a policy of continuous advancements in development. For this reason specifi-
cations may be changed without notice.
• Manufactured under license from Lucasfilm Ltd. Lucasfilm and THX are trademarks or registered
trademarks of Lucasfilm Ltd.
8
EN
For U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in
the instruction manual. The user could lose the authority to operate this equipment if an unautho-
rized change of modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment may cause harmful inter-
ference to radio communications, if it is not installed and used in accordance with the instruc-
tions. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
For your records
Record the serial number, found on the back of the unit, in
the spaces designated on the warranty card, and in the space
provided below. Refer to the model and serial numbers when-
ever you call upon your dealer for information or service on
this product.
Model
Serial Number