Advertisement
CO10RF 003.qxd_Layout 1 18.06.2014 13:40 Strona 2
Box Contents
Product Compliance & Safety Info
Zigbee Coordinator
Models: CO10RF
• Electro-Magnetic Compatibility directive
2004 / 108 / EC
• Low voltage Directive 2006/95/EC
I N S TA L L E R / U S E R M A N U A L
These instructions are applicable to
1 x Installer / User manual
the SALUS model stated on this
instruction guide.
This product must be fitted by a competent
person, and installation must comply with the
guidance, standards and regulations applicable
1 x CO10RF
to the city, country or state where the product is
installed. Failure to comply with the
requirements of the relevant guidance,
standards and regulations could lead to injury,
death or prosecution.
1 x USB Adapter
Always isolate the AC Mains supply before
1 x UK Plug + EU Plug Adapter
installing or working on any components that
require 230 VAC 50Hz supply.
For PDF Installation guide please go to
We hope you enjoy this product...
www.salus-controls.com
INSTALLATION
4
Insert the adaptor into 230V mains outlet.
6
To commence system installation press and
hold the button until for 5 seconds or the
button starts flashing red. This means the
Zigbee network is ready to accept iT600
devices.
7
5
Switch the 230V mains outlet on and
ensure the button is illuminated (red)
as shown above.
SYSTEM OVERVIEW
Product Compliance
INTRODUCTION
Thank for purchasing the SALUS CO10RF Zigbee
coordinator. The Zigbee coordinator controls the
Zigbee communication of your iT600 system.
Warning
SALUS Wiring Centre KL10RF
Warning
8
When everything is paired press and hold
button for 5 seconds or flashing stops.
Maintenance
If replacing or adding iT600
devices please ensure you
Please refer to individual
follow steps 6 to 8.
device manuals.
Please refer to individual device
manuals for more information.
iT600 System
CO10RF
RX10RF
CHECKING SYSTEM CONFIGURATION
Press for 1
second
to activate
identify mode.
INSTALLATION
The Zigbee coordinator must be used with
the iT600 RF range of products below:
1
VS10/20RF Thermostat
2
Attach plug adapter to the USB adapter
TRV10RF
To check that the complete system is
communicating and has been configured
correctly, you can use identify mode.
Press again for 1 second
to cancel identify.
Identify mode will time
out after 10 minutes.
UK or EU plug version
3
Attach Coordinator to USB adaptor.
Using identify from the
coordinator will show all products
that are connected to your system.
Advertisement
