Example Settings - Matrix Elements VB-800 Field Manual

EXAMPLE SETTINGS:

There's no right and wrong settings to use, it's all down to your individual
taste. The tone controls have a wide coverage so dialling in tones you like
should be easy. If it sounds good, go with it.
CONNECTIONS:
Listed below are some of the standard ways in which you may want to
hook up your VB-800.
Standard: Guitar
Delay input Delay output to VB-800 FX return. VB-800 speaker outs
Cab (remember to use FX send level to control the level to your pedals)
Tube Buffer: Guitar
VB-800 FX Send
4CM: (4 Cable Method): Guitar
Modeller FX loop send
800 FX Send Modeller FX Loop Return
800 FX Return. VB-800 Speaker Outs
Main Input
Recording: Guitar
Use cab sim software either in your DAW or before your DAW. (Remember
to use the FX send level to control the signal to your DAW)
Wah OD High Gain input of VB-800. FX Send
Low Gain input of VB-800 (gain level set low)
Input of Modeller or FX loop of modeller
Main input of modeller/Multi FX
Input of VB-800 (low or high to taste)
MULTI FX UNIT
Main Out
FX Send
FX Return
FX Send
SPKR OUT FX Return
This method allows the positioning of gain
inducing stompoxes before the VB-800s preamp
and time based effects in the VB-800s loop via
the modeller/multi FXs loop.
Fx (Wah, OD etc)
6
Modeller main Out
Cab
VB-800 FX send DAW.
VB-
VB-