Advertisement
Quick Links
Advertisement
Summary of Contents for Triax Zone 2 EASIFIT
- Page 1 Zone 2 EASIFIT Assembly Instructions Document Reference TQM 05-03-09 Revision: 01...
-
Page 2: Main Components
Main Components Item Description Antenna Antenna Bracket-Feed Arm Assembly Elevation Bracket Wall Tube Wall Bracket Fixing Kit Not Supplied: LNB, Feed Clamp and Mounting Button Fixing Kit Item Description M6 Serrated Flange Nuts M6 x 12 Painted Pozi-Pan M6 x 16 Cup Square M6 U Bolt... - Page 3 Assembly Instructions 1. Take the antenna bracket - feed arm assembly, unfold and rotate the feed arm until it reaches the locking position on the antenna bracket. (See the illustration below) 2. Fix the locked assembly on to the antenna using the 4 off M6 12mm painted Pozi-Pan screws and M6 nuts.
- Page 4 5. Insert the wall tube into the wall mounting bracket and secure using 2 off M6 U bolts and 4 off M6 nuts. Note: If the horizontal angle of the antenna from the wall is between +/- 55 degrees then the short end of the wall tube should be fixed to the wall mount. If the angle is to increase above 55 degrees (+/- 90 degrees) then the long end should be fixed to the wall mount. 6. After the wall mount has been fixed to the wall, clamp the antenna assembly to the wall mount assembly using 2 off M6 U bolts and 4 off M6 nuts.
- Page 5 Quality Installation Guidelines 1. Do not use the antenna face to make setting adjustments, use the bracketry. 2. Ensure the wall mount bracket is fastened with all 4 bolts, across at least 3 bricks and do not use the mortar lines. Never fit closer than 3 brick courses from the top of a wall or within 2 brick widths of an edge. 3.