VTech Go! Go! Smart Wheels User Manual page 11

Assemble the 360 Degree Loop Course
1. Place the loop track base on the left side of the assembled tower.
Use the base support to connect the tower and loop base. Then
insert the semicircular loop track into the slots on the top of the
loop track base as shown until you hear them "click" into place.
2. Insert the small track support piece into the slot on the back of the
tower as shown. Then connect the two long straight tracks together.
Insert the hooked end into the left side of the launcher and insert the
opposite end of the long track into the slot on the loop track base
until you hear them "click" into place. The fully assembled long track
should be attached to the notch on the small track support piece.
Assemble the Spiral Course
1. Slide the longer C-shaped track onto the notches located on the
right side of the launcher so it snaps into place. Then pass the
shorter C-shaped track through the archway on the top tower
piece and connect it to the end of the longer C-shaped track.
Once connected, insert the notch that is located at the base of the
archway into the hole that is located on the bottom of the shorter
C-shaped track until it snaps into place.
10