For Bi-Amp - Wadia a315 Owner's Manual

Output Terminal one quarter of a turn (90°). Do not
over tighten. Refer to figure E.
8. Referring to figure H, connect the Loudspeaker
hookup cables with banana
plugs into the hole at the end
of the a315 Negative and Posi-
tive Output Terminals, being
careful to observe the correct
polarities.
Refer to "General Information" Note 3 on page 4 for
additional information.
WARNING: Loudspeaker terminals are hazardous
live and present a risk of electric shock.
For additional instruction on mak-
ing Loudspeaker Connections contact
your Wadia Dealer or Wadia Technical
Support.
9. Connect the a315 Power Cord to an active AC
outlet.
Spade Lug or Wire Connections:
10. Connect the Loudspeaker hookup cables to the
a315 Negative Output Terminal and Positive
Output Terminal, being careful to observe the cor-
rect polarities. Insert the spade lug connector or
prepared section of the cable end into the terminal
side access hole, and tighten the terminal cap until
the cable is firmly clamped into the terminals so
the lugs or wire cannot slip out. Refer to figures 5
and 6.
Figure 5
Refer to "General Information" Note 3 on page 4 for
additional information.
WARNING: Loudspeaker terminals are hazard-
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections
contact your Wadia Dealer or Wadia
Figure H
Technical Support.
11. Connect the a315 Power Cord to an active AC
outlet.
Figure 6
How to Connect for Bi-Amp
13