Manual Tune; Changing The Information Display; Memorising A Station - Pioneer X-SMC00 Operating Instructions Manual

08 Using the tuner

Manual tune

You can manually store stations which Auto Scan cannot
find. If reception is poor, you can adjust the sensitivity.
Manual tune is only available after Auto tune. Perform Auto
Scan first.
1 Press the TUNER until "DAB" appears on the
display.
2 Press the DAB SCAN once.
3 Within 10 seconds, press the TUNE +/– to
select the DAB+ frequency.
4 Within 10 seconds, press the DAB ENTER.
• If the level is too low, move the aerial or unit to improve
reception.

Changing the information display

You can switch DAB+ display information.
Press the DAB DISPLAY button.
Each time the button is pressed, the information display
changes in the following order.
When "NO SIG" appears, the DAB DISPLAY button does not
allow you to change the display.
[Station Name]
Station name is displayed. (set by default)
[Scrolling text]
Information scrolls across the display when sent from the
station.
[Programme type]
A description of the type of content being broadcast by the
station.
[Multiplex name]
The name of the multiplex (ensemble) which provides the
current service.
[Frequency]
The DAB+ frequency for the station.
[Stereo mode]
Display stereo mode.
[Transfer speed]
The data transfer speed.
[Signal quality]
The signal quality is displayed as a number (0 - 100).
[85-100: Good, 70-84: Fair, 0-69: Poor]
26
En

Memorising a station

You can store 10 DAB stations in memory and recall them at
the push of a button. (Preset tuning)
1 Tune to the desired DAB station.
2 Press the MEMORY/PROGRAM.
The preset number will flash.
3 Within 10 seconds, press the PRESET +/– to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 10 seconds, press the MEMORY/
PROGRAM to store that station in memory.
If the preset number indicators disappear before the station is
memorised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to
change a preset station.
When a new station is stored in the memory, the station
previously memorised for that preset channel number will be
erased.