Table of Contents
Advertisement
SeeSnake
If you don't have the SimulTrace™ feature, use a line
transmitter and a locator to line-trace the pushrod. When
the signal fades, switch the locator to Sonde mode at the
frequency of the in-line Sonde, usually 512 Hz. Pick the
signal up from where the line-trace frequency started to
weaken and zero in on the in-line Sonde. Because locat-
ing frequencies from transmitters can cause distortion of
the image on the monitor, it is best to turn Sonde and line
transmitters off while inspecting the interior of a line and
turn them on only when ready to do a locate.
Maintenance Instructions
Cleaning
WARNING
Make sure all cords and cables are disconnected
and the battery removed prior to cleaning the
DVD Pak to reduce the risk of electrical shock.
Do not use liquid or abrasive cleaners on the DVD Pak .
Clean the DVD Pak with damp cloth. Only use cleaners ap-
proved for use on LCD screens to clean the screens.
Do not allow any liquid to enter the DVD Pak .
Accessories
WARNING
The following accessories have been designed to
function with the DVD Pak . Other accessories suit-
able for use with other equipment may become
hazardous when used with the DVD Pak . To reduce
the risk of serious injury, only use accessories
specifically designed and recommended for use
with the DVD Pak , such as those listed below.
Catalog #
Description
US
EU
32743 28218 18 V Li-Ion rechargeable battery
32068 32073 Battery charger
32648 32693 Dual battery kit with charger
32708 32713 Single battery kit with charger
Various
RIDGID SeekTech
Various
RIDGID SeekTech
Transmitters
14
DVD Pak
®
®
or NaviTrack
®
Locator
®
or NaviTrack
®
Ridge Tool Company
Transport And Storage
Remove batteries before shipping. Do not expose to
heavy shocks or impacts during transport. If storing for an
extended period, remove batteries. Store within temper-
ature range of -4°F to 158°F (-20°C to. 70°C).
Store electrical devices in a dry place to reduce the risk of
electrical shock.
Protect against excessive heat. The unit should be situated
away from heat sources such as radiators, heat registers,
stoves or other products (including amplifiers) that produce
heat.
Service And Repair
WARNING
Improper service or repair can make the DVD Pak un-
safe to operate.
Service and repair of the DVD Pak must be performed by
a RIDGID Independent Authorized Service Center.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find
your local Ridge Tool contact point.
• Contact Ridge Tool Technical Services Department
at rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.
Disposal
Parts of the unit contain valuable materials and can be re-
cycled. There are companies that specialize in recycling
that may be found locally. Dispose of the components in
compliance with all applicable regulations. Contact your
local waste management authority for more information.
For EC Countries: Do not dispose of electrical equip-
ment with household waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national legislation, electrical
equipment that is no longer usable must
be collected separately and disposed of in an environ-
mentally correct manner.
Advertisement
Table of Contents
