Monitor And Dvdr Power-Up - RIDGID SeeSnake DVDPak User Manual

SeeSnake
Battery Power
With dry hands, slide a fully charged battery onto the bat-
tery dock on the back of the DVD Pak .
Figure 6 – Battery Installed
Make sure that the battery locks onto the dock. See the
Battery Charger operator's manual for more information.
Batteries supplied for the DVD Pak are rated at 2.2 amp-
hours. When fully charged, depending on use (recording
time, etc.) the DVD Pak will run for approximately 2.5 to 3
hours. Battery Status LED's indicate battery charge level
(Figure 7) . See Battery Status LEDs Chart.
Figure 7 – Battery Status LEDs
Battery Status LEDs Chart
Battery External
Status Power Not
Connected
FULL Solid green
MED Solid green and red
LOW Solid red, 4 beeps
DEAD Solid red for 5 sec,
5 sec long beep
and shutdown
8
® DVD Pak
External
Power
Connected
Green blinking
(5 sec OFF 0.2 ON)
Green and red blinking
(5 sec OFF 0.2 ON)
Red blinking
(5 sec OFF 0.2 ON)
Ridge Tool Company
Outlet Power
For plug in operation, a double insulated AC/DC power
supply is supplied to reduce wall outlet voltage to the cor-
rect voltage for the DVD Pak .
NOTICE The external power supply is intended for in-
door use only.
To power the system up with the power cord, locate
the power supply. The power supply cord has two sec-
tions, one of which plugs into a standard 110-120V two-
bladed outlet (US) at one end and plugs into a power
supply at the other end. The second section runs from
the power supply to the back of the DVD Pak and plugs
into the jack marked 40 Watts—14-16V at the far right
side of the back of the unit (Figure 8) .
Figure 8 – Connected External Power Supply
With dry hands, connect the two sections together and in-
sert the jack plug into the jack on the back of the DVD Pak .
Route the cord along a clear path and with dry hands plug
the power supply into a matching outlet. If using an ex-
tension cord ensure it is of adequate wire gauge. For
cords of 25 feet, a minimum gauge of 18AWG is re-
quired. For cords greater than 25 feet, a minimum gauge
of 16 AWG is required.

Monitor And DVDR Power-up

Once connections are in place and batteries installed (if
used), you can power up the DVD Recorder and the
DVD Pak monitor with a single press of the Power Button
. You can also power the monitor independently by
pressing the Power Key
use the monitor without powering up the recorder to con-
serve battery power.
If you power the monitor on separately using the
display Power Key , remember to turn it off using
the display Power Key. If you power the monitor and
DVDR up by pressing the DVDR Power Button
use the DVDR Power Button to turn the unit OFF.
on the keypad. This lets you
,