Tape Recording And Playback - Technics SU-7300 Operating Instructions Manual

TAPE RECORDING AND
PLAYBACK
When the recording mode selector
position, the signal which has been selected with the Input
selector 121 is constantly supplied, as a signal for recording,
from the tape deck 1 and tape deck 2 recording output ter-
minals. In this instance, all operating controls, such as the
volume controle (5) and tone controls (3), have no effect upon
the recording.
(12)
Set the Input selector
source which is to be recorded ("PHONO'', "TUNER" ).
Set the recording mode selector (10) to the ''SOURCE"
position.
Prepare the tape deck for recording.
The program which has been selected with the Input
selector (12) is then recorded onto the tape.
Be sure to adjust the recording level of the tape
deck. Recording check
The recording condition can be checked by using the tape-
monitor selector il;. The sound prior to recording can be
heard from the speakers by setting the tape-monitor
selector '1 t: to the ''SOURCE'' position, and the sound
which has just been recorded can be heard from the
speakers by setting it to the appropriate ("TAPE 1" or
"TAPE 2") position.
Playback from a tape deck
Select the tape deck with the tape-monitor selector (c.
(The Input selector 12 has no effect in any position.)
For playback from tape deck 1,set the tape-monitor
selector (11) to the "TAPE 1" position.
For playback from tape deck 2, set the tape-monitor selec-
tor ( to the "TAPE 2" position.
1 1)
(10)
is in the "SOURCE"
according to the program
After preparing the tape deck for playback, increase the
volume gradually to the most comfortable listening level.
Tape "dubbing"
Tape-to-tape recording ("dubbing") from tape deck 1 to tape
deck 2, and from tape deck 2 to tape deck 1, is possible with
this unit.
The direction of the dubbing (from tape deck 1 to 2 or from
tape deck 2 to 1) is selected by using the recording mode
selector (10).
If this selector is set to the "TAPE 1>2" position, tape dubbing
from tape deck 1 to 2 is possible; if it is set to the "TAPE 2>1"
position, tape dubbing from tape deck 2 to 1 is possible.
Dubbing check:
The dubbing condition can be checked by using the tape-
monitor selector i (11) . If this switch is set to the "TAPE 1''
position the sound from tape deck 1 will be heard, if it is set to
the "TAPE 2" position, the sound from tape deck 2 will be
heard.
Figure shows the path of the signal when a recording is
made from tape deck 1 to tape deck 2. The monitor signal
(the sound from tape deck 2 immediately after recording)
is heard from the speakers.
As shown in figure, if the tape-monitor selector
the''SOURCE'' position,
circuitry becomes completely independent. Accordingly,
during tape-to-tape recording, the source signal which has
been selected by the
reproduced in the same way as for ordinary operation.
7
is set to
-
1 1;
the tape-to-tape recording
input selector (12) can be