Yamaha RX7 Authorized Product Manual page 42

* Reception of bulk data will erase the corresponding data
in the RX7.
OPERATION
1 . Select Job #08.
The display will ask
2 . You can now select the type of bulk data you wish to
receive from among the following with the -1/NO and
+1/YES keys.
1. Seq&Voice
2. Pattern 00 (single Pattern)
3. Voice 00 (single Voice)
4. Setup
3 . (If you select data type 2. or 3., you must also enter the
Pattern or Voice number using the numeric keys.)
4. Transmit a dump request to the connected MIDI device
by pressing ENTER.
* If the device number has been set to OFF with Job #07,
the error message
will appear. Set the correct device number and repeat the
bulk dump request.
JOB #09: BULK TRANSMIT
FUNCTION
Transmit bulk data to other MIDI equipment.
To be able to use this function, the external MIDI device
must be set to receive bulk data. Make sure that the same
device number is selected on both the RX7 and the other
MIDI device.
OPERATION
1. Select Job #09.
The display will ask
2. You can now select the type of bulk data you wish to
transmit from among the following with the -1/NO and
+l/YES keys.
1. Seq&Voice
2. Pattern 00 (single Pattern)
3. Voice 00 (single Voice)
4. Setup
3. (If you select data type 2. or 3., you must also enter the
Pattern or Voice number using the numeric keys.)
4. Transmit the selected bulk data to the connected MIDI
device by pressing ENTER. During data transmission,
the LCD will show
If transmission has been successful, the LCD will revert to
the previous display.
* If the device number has been set to OFF with Job #07,
the error message
will appear. Set the correct device number and repeat bulk
transmission.
* Except during playback, recording (writing) or execution
of cassette/cartridge jobs, the RX7 will respond to a dump
request from a connected MIDI device by transmitting
bulk data if the device number has been set accordingly.
37