Black Tank Flush System - Fleetwood PaceArrow Vision 2000 User Manual

PIUMbiNq SYSTEMS
The black water holding tank is equipped with rinsing spray
heads that will aid in the removal of sewage residue from the
interior of the holding tank. To operate the tank flushing sys-
tem, follow the procedures for Dumping The Holding Tanks
in this chapter. After dumping the gray water tank proceed as
follows:
1. Connect a garden hose to the 6" stub hose with the quick
connect coupler.
2. Insert the quick connect coupler into the flush inlet. This
connection is labeled, "SEWER VALVE MUST BE OPEN
WHEN USING THIS INLET."
3. Open the black water sewer valve. THIS VALVE MUST BE
OPEN.
4. Open the water valve at the quick connect coupler and at
the water supply.
5. Rinse the tank for 2-3 minutes or until the water is running
clear from the sewer hose.
6. Turn off the fresh water and disconnect the hose.
7. After rinse water has thoroughly drained from the black tank
close the knife valve and replace the termination cap. If you
are parked at a site with a semipermanent sewer hookup,
keep the black water knife valve closed to allow the waste
level to build up. The outlet will probably clog if you leave
the knife valve open continually. Run enough water into the
tank to cover the bottom. This will aid the break up of solid
wastes.
Please .. . Practice good housekeeping when draining wastes
at a campsite or disposal station. Leave the site in good
order. Above all, do not pollute.
BLACK TANK
FLUSH SYSTEM
CAUTION
Do not use the same
hose you use for filling
the potable water tank, or
for connection to the city
water inlet. This is espe-
cially true if you the con-
nect the quick connect
hose to the typical rinsing
hoses at most dumping
stations. Use of a differ-
ent hose will insure that
you will not contaminate
your fresh water supply.
CAUTION
The sewer drain valve
must be open when using
the SAN-T-FLUSH inlet.
PACE AI/I/ow VisiON
-
I . ~