Table of Contents
Advertisement
14
MINI-BLINDS
Torllise mini-blinds: Release bottom of blind from
retainer. Pull straight down on cord and release at
desired height. It is not necessarY topull the cord to one
side or the other to secure blind.
.
To lower mini-blind: Pull straight down on the cord
slightly, and move it about 45 degrees to either the left
or right and lower the blind. Stop the blind in mid-travel
by moving it back to the straight down position. Reattach
the retainers when traveling.
To IIdjust the lingle: Turn the adjusting rod either
direction .
. RO.OF RACK LADDER INSTALLATION
.. (Somerilodels only)
To install the exterior roof rack·ladder:
1. Remove the bottom section of ladder from stor-
age location in overhead cabinet. .
.
,
.,
; .
" ,
;.-
,
.
~.
:-
....
-,
2. Remove top section of ladder from right rear
storage compartment.
3. Place upper and lower sections of ladder to-
gether. Be sure that metal safety catch and bunk
hooks face toward the motor home. Secure by
turning both large knobs until tight.
11 '''
4. Raise ladder.intopositioh.on·the.rear. cap" Slid
guide armsintoslots located;atthe.topcenterof
the cap. Raise ladder high enough so ·Iower
section can be inserted into holes in the. bumper •
NOTE:For night installation, turn on rear utility
lights with switch near entry door. Turn lights off
after use.
WARNING
REMOVE AND STORE LADDER BEFORE
TRAVELING SINCE IT MAY BE DISLODGED
BY MOYEMENT.
To remove ladder, grasp safety latch at bottom right leg
. of ladder. Depress latch and raise ladderto clear bumper.
Remove ladder from top slots, disassemble and store.
Advertisement
Table of Contents
