Ekasand 75 x 100 mm Operator Instructions Manual

EKASAND
75 x 100 mm (3 x 4 in.)
Orbital Sander

Features

:
• Free Speed of 10,000 Orbits Per Minute
• Variable Speed Control with Palm Style On/Off Lever
• 3 Sizes of Ergonomic Cushion-Grips for comfort and
stability
• Low Profile for Operator Control and Comfort
WARNING
Always wear safety
goggles to protect your
eyes.
OIL DAILY
Oil daily for superior
performance.
1) General Industry Safety & Health Regulations, Part 1910, OSHA 2206,
available from: Superintendent of Documents; Government Printing Of-
fice; Washington DC 20402
2) Safety Code for Portable Air Tools, ANSI B186.1 available from: Ameri-
can National Standards Institute, Inc.; 1430 Broadway; New York, NY
10018
3) State and Local Regulations.
Key parts of the above regulations are excerpted below. They are not in-
tended to be inclusive. Study and comply with all regulations.
1) TOOL INTENT – Tool shall be used only for purposes intended in its
design.
DOC 1114
• Rear Exhaust Directs Air away from work
• Suggested Applications:
Sanding and Finishing a Variety of Materials including
Wood, Metal, Plastic, Fiberglass Composites, Solid
Surfaces and other Sandable Surfaces
Operators Instructions
Includes – Features and Suggested Applications, Please Read and Com-
ply, Assembly Drawing of Machines, Parts List, Proper Use of Tool, Work
Stations, Putting the Tool Into Service, Operating Instructions, EKASAND
Service Tools and Accessories, EKASAND Back-Up Pads™, EKASAND
Service Kit, EKASAND Warranty
Important
Read these instructions carefully before installing, operating, servicing or
repairing this tool. Keep these instructions in a safe, accessible location

Please Read and Comply With

2) AIR SUPPLY – Test and operate tools at 90 PSIG (6.1 Bar) maximum
unless tool is marked otherwise. Use recommended airline filters -
regulators – lubricators (FRL).
3) UNUSUAL SOUND or VIBRATION – If tool vibrates or produces an
unusual sound, repair immediately for correction.
4) OPERATOR PROTECTIVE EQUIPMENT – Wear goggles or face
shield whenever tool is in operation. Other protective clothing shall be
worn, if necessary.
5) SAFETY MAINTENANCE PROGRAM – Employ a safety program to
provide inspection and maintenance of all phases of tool operation and
air supply equipment in accordance with "Safety Code for Portable Air
Tools."
1
EKASAND TOOLS
© EKASAND•0701
.
04/26/06