Advertisement
EPISODE
Discharge Pump ( Optional):
Up to 4ft @ +/- 39 sec. with 1/2" Connection to main drain
Fastner
On/Off
Switch
Air Check Valve
Clear Tubing 3/4 OD ½"ID
Rubber Gasket
Poly Insert 90 Elb ½"
Elbow
(LARGE Rubber Coupling)
3/4" PVC Pipe
Installation Instruction
1.
Make a hole ( size 1-3/8") for the On/Off switch as shown (see fig 1). Pre-
drill required.
2.
Placed a 1/8" clear hose into the rear of the switch and on/off switch into the
hole.
3.
The discharge pump kit is made to fit onto the pedicure unit. (see fig 2)
4.
Connect E-Z connector onto the drain elbow.
5.
Plug discharge pump outlet into the two minute timer outlet
6.
Plug two minute timer into the wall outlet.
7.
It is very important that tip of the clear tub remain above the water Level with
one loop as shown.
** Please cut to fit 1" Flex hose to your size**
Operation Instruction
Warning !
DO NOT RUN DRY
1.
Turn to open drain plug. 3 to 5 second for air to release from the pipe
2.
Press On/Off switch to activate timer.
3.
At any time, water drain completely from the basin. Press
On/Off switch to stop or built in two minute timer.
LX
(SMALL Rubber Coupling)
3/4" Elbow
TEE 3/4 X 3/4 X ½
HANNING DPO 40 - 020
LARGE Rubber Coupling
½" Discharge Outlet.
DRAIN OUTLET MUST BE ½"
or 3/4" FOR EFFICIENT DRAINAGE.
½"X ½" Brass
Check Valve
PLUMBER MUST BE UTILIZED TO INSTALL
CHECK VALVE and Utility Valves for Hot / Cold Water
3/4 PVC Pipe
3/4" PVC Pipe
3/4 SLIP X ½" Male Adaptor
Electrical Control Box
(Located left bottom
inside of base)
3/8" clear Tube
from On/Off Switch
for Part time control box
Power Plug
to wall outlet
Pipeless Motor
Power Plug
FULL TIME
2 Min.Timer
(D.pump)
3/8" Clear Tube from on/off for D/P pump
insert into 2 Min. Timer.
Make sure to push in tightly.
1-3/8" Hole
for On/Off Switch
Figure 1
Fastner
On/Off
Switch
Advertisement
