Advertisement
key. The display reads:
T
, then the
r you selected will flash:
ABOUT TYPING
/
key to
• Additional symbols not
SPACE
CHECK
aces.
found on the keyboard can
be accessed by selecting the
make a mistake, use
number/symbol mode, and
and
SOR L
CURSOR R
then using the
highlight the incor-
/
UP
racter, then use the
through the available sym-
ey to erase it.
bols.
3: Press the
key again. The display
SET
will stop flashing and will change
to the alphanumeric character dis-
play:
(keys shown in dark gray)
.
CHAR
SEARCH
keys to scroll-
DOWN
4: Use the keyboard to type the disc name. Wait until you
see the alphanumeric character list on the changer's dis-
play before typing. Typing too soon can cause undesired
operation of the changer.
For more information about typing, see the notes at the
bottom of the page.
CD-3280M, CD-3260M, CD-324M:
• You can also use the
CHAR CAPITAL
and
CHAR SMALL
CHAR SYMBOLS
shift between capital letters, lower-
case letters and numbers/symbols.
5: After you have typed-in the
entire title, press the
key. The display reads:
6: The display then switches to
show the disc number, and
the first track number flashes:
7. Repeat steps 3 - 5 to enter a
title for the disc's first track.
8. Repeat steps 3 - 5 for each
track title you want to enter.
Discs with CD Text
Some record companies encode
CD Text information (titles, artists,
musical genre, etc.) onto their
CDs. Your Kenwood changer will
read this CD Text information and
it will overwrite any title or musi-
cal genre information that you
input into the changer.
CD-2280M, CD-2260M, CD-224M:
,
• To store a number as part of a title,
keys to
press the
SET
ber.
• You cannot access yellow-colored sec-
ondary symbols.
• Since the keyboard must transmit a
series of commands each time you
press a key, it may seem to respond a
bit more slowly than a typical wired
computer keyboard.
ENTER
key after typing the num-
Advertisement
