Switch Module Leds - Cisco Nexus 4001I Installation Manual

Chapter 1 Product Overview

Switch Module LEDs

This section describes the LEDs on the Switch Module and includes the following topics:
•
•
•
•
Location of LEDs
You can use the switch module LEDs to monitor switch module activity.
that are described in
Figure 1-2
10
1
3
5
7
9
Uplink 10 Gb Ethernet Port LEDs
The Switch Module port LEDs are described in
The Activity LED blinks green or is off to indicate link activity. The Link Status LED is either solid
green or off.
Port LED Indications
Activity LED Indication
Off
Off
Blinking green
Blinking green
OL-19951-03
Location of LEDs, page 1-5
Uplink 10 Gb Ethernet Port LEDs, page 1-5
System Status LED, page 1-6
Management Port LEDs, page 1-6
Table 1-1,
Switch Module LEDs and System Activity LEDs
1 2
9
10 Gb Ethernet port 15 Link and Activity LED 2
10 Gb Ethernet port 17 Link and Activity LED 4
10 Gb Ethernet port 19 Link and Activity LED 6
Out-of-band management port Activity LED
System Status Fault LED
Table 1-1
Cisco Nexus 4001I and 4005I Switch Module for IBM BladeCenter Hardware Installation Guide
Table 1-2, and Table 1-3.
3
8 7
10 Gb Ethernet port 16 Link and Activity LED
10 Gb Ethernet port 18 Link and Activity LED
10 Gb Ethernet port 20 Link and Activity LED
8 Out-of-band management port Link LED
10 System Status OK LED
Table 1-1. Each of the six uplink ports has two LEDs.
Port LED Indications During Normal Operation
Link Status LED Indication
Off
Solid green
Solid green
Off
Hardware Features
Figure 1-2 displays the LEDs
4 5 6
Port Status
LED Description
No link established
No activity but link established
Activity (traffic) on an established link
Activity (traffic) on an established link
and port disabled (error disabled, STP
blocked)
1-5