Memorizing Frequently Used Settings: Program Function; Registering A Program; Using Programmed Setting To Make Copies - Utax CD 1016 Instruction Handbook Manual

Section 5 COPY FUNCTIONS

Memorizing frequently used settings: Program Function

Copy settings that are frequently used can be registered and then
recalled up by pressing the Program key. Even types of copies can
be stored.

Registering a program

1
Set the Copy Mode to be registered.
2
Press the [Program] key for 3 seconds.
3
Input the program number (0 to 9) using the Keypad and
press the key for 3 seconds.
The display of the number input will blink 2 times and the
program will be registered.
Note
If the same number as a program already registered is
input, the prior program is overwritten.
5-18
Using programmed setting to make
copies
1
Press the [Program] key.
2
Press either the Zoom (+) or Zoom (–) key, select the
number of the program to be called and then press the [OK]
key. Input can also be done using the Keypad.
Inch specifications
3
Set the original and press the [Start] key.
The copy will be made using the program that has been set.
Metric specifications