Installing/Using Celldisk In Microsoft Windows Me/2000/Xp - IOCELL CellDisk User Manual

When using Microsoft Windows ME/2000/XP, MAC 9.0 or
higher, Linux 2.4.0 or higher, CellDisk can be installed and
removed without powering down your computer. When using
Microsoft Windows 98/98SE, you must install additional drivers
before you can use the CellDisk.
The additional Windows 98/98SE drivers can be downloaded
from the
included CD-ROM.
For Linux, it is required to mount SCSI.

Installing/Using CellDisk in Microsoft Windows ME/2000/XP

1. Start Windows ME, Windows 2000 or Windows XP.
2. Remove the cover from your CellDisk and plug it into a USB port on your
computer.
If it is the first time to use CellDisk, Windows will automatically recognize it and
install all required drivers.
3. The red Status LED will flash during the recognition and installation
procedures. When CellDisk is ready to use, the Status LED will turn off.
4. Click My Computer on Windows Desktop. CellDisk is displayed as a
removable disk, as is shown in the following figure (The drive name may be
different depending on the system you are using).
5. You can now read or write data using the installed CellDisk, the same as with
any other hard drive.
www.celldisk.com homepage or loaded from your
5