Advertisement
DIRECTIONS FOR USE
7. Power Button
Before turning on make sure there is water in the unit.
Press the Power Button.
8. The current humidity level in the room will be shown
on the display. The humidity reading will not display
below 35%.
9. Timer Button
Press the Timer button and set the number of hours you
would like your Germ Guardian™ Ultrasonic Humidifier to run
(1-hour, 2-hours up to 12 hours).
· If you press the button during operation the remaining time
is displayed.
· Press it again to adjust the time.
Co - means Constant Humidification.
10. Humidity Control Button
When you press the Humidity Control Button
there are four options to choose from:
Press once for weak
Press twice for middle
Press three times for strong
Press four times for turbo
* You will notice the lights get higher as the spray increases.
11. Auto
Press once for auto. This will adjust the humidity setting to 80%
humidity - warm humidification!
Sleep
Press twice to activate sleep mode. This will turn on the moon icon
and turn off all other display lights.
E-6
(cont)
DIRECTIONS FOR USE
(cont)
12. Press to select cold or warm humidification. Water temperature
is maintained at 40 degrees for cold and 80 degrees for warm.
13. Press the Humidity Control Button to change the humidity level.
· Humidity level options include: 50%, 55%, 60%, 65%, 70%,
75%, 80%.
· Five seconds after pressing this button the current humidity
level will be displayed.
This will not affect the spray output!
Co - means Constant Humidification.
14. Water Refill Button
When the Water Refill Button lights up it is time to refill
the water tank.
15. Night Light Button
Press the night light button at the top of the unit to illuminate
the night light feature.
16. Press to display the current temperature in your room.
E-7
Advertisement
