Table of Contents
Advertisement
Chapter Ten FAQ (Frequently Asked Questions)
01：Why the DVR did not run after connect the power supply?
①Please check the power switch turn on or off at the rear panel of DVR.
②Please check if the turn on DVR operation correct or not?
③If you select the adaptor +12V, 5A or above? (8ch 5A, 16ch 220V 200W)
02：Still stop over on the boot-strap frame?
Physical damaged in hard disk drive
Boot manager abnormal.
03：Why does appear the boot running too slow?
①There are too much capacity data in hard disk drive, the system will automatic search the data when
the system boot up, caused the boot
② The hard disk drive error will cause the system research the data repeatedly, caused the boot
running slow.
04：Why does the system reboot repeatedly?
①Check the hard disk drive, if there is not the FAT32 formatted in it or the problem in it and caused the
Pause
When the program connects with device,
Esc
Go to the previous level.
Previous group
It can show the previous channels group.
Next group
It can show the next channels group.
Choose one video channel of the device. And cooperate with "next
Select channel
group" can switch the 9 to 16 channels.
running slow.
96
pause video
Advertisement
Table of Contents
