Kenwood KDC-8021 Instruction Manual page 47

Troubleshooting Guide
?
Can't enter Album Select mode.101
There's no folder recorded in the MP3/WMA media.
Use a media with levels.
?
The songs in the selected folder aren't played in Album Select
mode.102
There are no MP3/WMA in the selected folder.
Make sure there's recorded content in the MP3/WMA media.
?
The MP3/WMA track/album search takes
Many tracks are recorded on the media.
When the media directory is complex, the track/album search can
take time.
?
The MP3/WMA related text isn't displayed
A character is entered that this unit can't display.
For the characters that can be used for MP3/WMA text entry,
refer to <Notes on playing MP3/WMA> (page 6).
?
The MP3/WMA track time isn't displayed
---
There are times when it isn't displayed correctly according to the
MP3/WMA recording conditions.
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
time.78
correctly.79
correctly.80
— 47 — — 47 —
The messages shown below display your systems
condition.
Eject: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
No Disc: No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
TOC Error: The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
Clean the CD and load it correctly.
E-05: The CD is upside-down.
Load the CD correctly.
Blank Disc: Nothing has been recorded on the MD.
No Track Disc: No tracks are recorded on the MD, although it has a
title.
E11
No Music Data: Media was played that doesn't have data recorded
that the unit can play.
Use media that has data recorded that the unit
can play.
No Panel: The faceplate of the slave unit being connected to
this unit has been removed.
Replace it.
E-77: The unit is malfunctioning for some reason.
Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
E01
E02
E05
E10
E15
E30
E77