Table of Contents
Advertisement
3.3 Powering On
Install the Compact Flash card, however to reduce the risk of errors it is
•
advised to have the power off when removing or installing a Compact
Flash card.
Connect the provided external AC power supply unit.
•
Power on the unit using the on/off switch, the power LED should come on.
•
(Note: In Openframe version (VF-215WHD-OF), the power is default to "Auto on".)
See the following section for Power On options.
3.4 Autoplay / Manual Playback at power startup
The Digital View VideoFlyer supports AutoPlay or manual playback modes at
power startup
AutoPlay: This is the default mode for the unit. This means that upon power-on
video will start playing in accordance with a playlist (if DV Studio was used to
transfer the media files to the Compact Flash card) or in alpha-numeric order (if
the media files were simply copied to the Compact Flash card).
Manual Playback: Only available as a setting in DV Studio. In Manual Playback
mode, after power up press any button and the first track in the Playlist set in DV
Studio will play.
3.5 Playback modes
Playlist mode, i.e. using DV Studio:
When operating in playlist mode, both project file (*.prj) and playlist file
•
(*.pll) must be present on the Compact Flash card. These are used to
control the sequence for all video tracks. If playback does not run as
expected please check that these files are present on the Compact Flash
card.
The project and playlist file are created using DV Studio software. Using
•
this software, you can set simple sequences or complex sequences
including "jump track" or "next track" actions. The software can also
program buttons with different functions like "play", "stop", "pause",
"mute", "previous", "next" and "volume".
Page 7 of 15
Advertisement
Table of Contents
