Advertisement
Advertisement
Table of Contents
Related Manuals for Lotus Prestige Integra
Summary of Contents for Lotus Prestige Integra
- Page 1 Mounting and User Instructions Lotus-Prestige Integra Version 1, 05/05-2014...
-
Page 3: Mounting Of Stove
Introduction Congratulations on your new Lotus Wood Stove We sincerely trust that your Lotus Wood Stove will bring many happy hours for you. However, to benefit fully from your investment, you should read these instructions thoroughly. They contain some specific advice on how to benefit fully from your stove –... - Page 4 Distance to Combustible Material For combustible material, such as combustible walls, furniutre, etc., for reasons of safety a number of minimum distances apply. The following minimum distances apply: Front 800mm Distance to non-combustible material For non-combustible material, there should be a distance of 80-100 mm in order that the stove may release and distribute the heat while you may clean on and around the stove.
-
Page 5: Combustion Air Supply
Floor When placing your new Lotus stove on the floor, it should be put on a non- combustible plate, for instance of steel or stone material. The plate should be so large that it will reach a minimum of 30cm in front of the stove, and 15cm at each side of the fireplace opening. -
Page 6: Use Of Stove
Chimney Sweep When your new stove has been mounted, do remember to report the installation to the chimney sweep. For one thing, the installation will have to be inspected, and the chimney should also be cleaned by the chimney sweep in the time ahead. -
Page 7: Sound Advice
Cleaning of Stove All Lotus stoves have been factory surface treated with original Senotherm lacquer in ”coke” or ”grey” colour. Due to this treatment, the stove will, during the first kindlings, exude a special odour but that will vanish after a few times. - Page 8 required. The ashes from the wood stove may contain embers long after the stove was used last time so always put the ashes in a fireproof bucket prior to removal. Do remember that your stove should be cleaned in cold condition only.
- Page 9 Wood for your Lotus stove should have a diameter of 7-9cm and be max. appr. 30 cm long as it will otherwise come too close to the stove sides (at the DS testing 25cm long wood has been used).
-
Page 10: Operating Trouble
Operating Trouble In case of any operating trouble with your Lotus stove, you may find the cause of that below. If not, please do not hesitate to contact your Lotus distributor. Stove hard to control – burning too quickly If your stove is new, check our guide. - Page 11 Installation with non-flammable materials. Examples of installation of flue pipe. The potential for the building-in of fireplace inserts is vast; they may be built into the wall, on the outside of the wall, and may be suspended on the wall. Building-in shall take place in connection with non-inflammable materials only.
- Page 12 By setup in connection with inflammable material, you must create a structure to the stove, by a steel frame and super isol plates (or plates of equal or better insulation), see example with minimum measurements. The Base The base must, of course, be firm and have adequate load-bearing capacity.
- Page 14 Lotus Heating Systems A/S. This warranty does not cover damage caused by inappropriate, non-expert/incompetent use of the stove. If a product is returned to Lotus Heating Systems A/S, and the damage subsequently turns out not to be covered by this warranty, any costs incurred shall be incumbent on the customer.