Advertisement
BREWING COFFEE USING A K-CUP® CAPSULE
1 Place your coffee maker on a dry, level, heat-resistant
surface.
2 Place the water reservoir filter in the water reservoir.
3 Fill the water reservoir with 6 to 10 oz of water. The water
levels are marked on the water filter. DO NOT place any
liquid other than water in the water reservoir.
4 Press the brew chamber release button on the top, front of
your coffee maker to release the top cover.
5 If the brew basket is inside is the brew chamber, remove it.
Place the K-Cup capsule holder into the brew chamber.
6 Insert a K-Cup® capsule into the capsule holder. NEVER
remove or puncture the foil top of the K-Cup® capsule
before inserting it into your coffee maker.
7 Close the top cover of your coffee maker. Make sure that it is
completely closed.
Note: If the top cover is not completely closed, the capsule
puncturing mechanism does not puncture the K-cup
capsule.
8 Place a mug on the drip tray, under the brew spout.
9 Plug the power cord into a power outlet, then press the
CAPSULE button. The brew cycle starts and the CAPSULE
button flashes throughout the brewing cycle.
10 The CAPSULE button stops blinking and your coffee maker
turns off when the brew cycle is over.
Tip:
•
For stronger coffee, use fill the water reservoir with less
water.
•
Keep the mug in place at the end of the brew cycle to
catch any excess drips.
•
To stop the brewing cycle at any time, press the flashing
CAPSULE button.
Note: Do not leave a used coffee capsule in your coffee
maker. Wait for your coffee maker to cool, press the brew
chamber release button, then carefully remove and discard
the used capsule. Lower the top cover.
BREWING COFFEE USING COFFEE GROUNDS
1 Place your coffee maker on a dry, level, heat-resistant surface.
2 Place the water reservoir filter in the water reservoir.
3 Fill the water reservoir with 6 oz to 14 oz of water. The water
levels are marked on the water filter. DO NOT place any liquid
other than water in the water reservoir.
4 Press the brew chamber release button on the top, front of your
coffee maker to release the top cover.
5 If the K-Cup capsule holder is inside is the brew chamber,
remove it. Place the brew basket into the brew chamber.
6 Place coffee grounds into the brew basket. NEVER fill above the
MAX marking.
7 Close the top cover. Make sure that it is completely closed.
8 Place a mug on the drip tray, under the brew spout.
9 Press the GROUND button. The brew cycle starts and the
GROUND button flashes throughout the brewing cycle.
10 The GROUND button stops blinking and your coffee maker
turns off when the brew cycle is over.
Tip:
•
For stronger coffee, use fill the water reservoir with less
water.
•
Keep the mug in place at the end of the brew cycle to catch
any excess drips.
•
To stop the brewing cycle at any time, press the flashing
GROUND button.
Note: Do not leave used coffee grounds in your coffee maker.
Wait for your coffee maker to cool, press the brew chamber
release button on the top, then carefully remove and empty
the brew basket. Lower the top cover.
DESCALING:
Residue from coffee or water may build up in your coffee maker.
You should descale your coffee maker on a regular basis to remove
the residue. The frequency for descaling your coffee maker
depends on amount of use and local water conditions. As a general
rule, you should descale every three months. Specific descaling
products for coffee makers are available in stores and online. If you
use a descaling product, follow the instructions that came with the
product.
You can also use white vinegar to descale your coffee maker.
To descale your coffee maker:
1 Make sure that your coffee maker's power cord is disconnected
from the power outlet.
2 Fill the water reservoir with undiluted white vinegar.
Note: If you are using a descaling product, follow the
instructions that came with the product.
3 Place a mug on the drip tray, under the brew spout.
Note: Make sure that your mug is large enough to hold all of
the contents in the water reservoir.
4 Make sure that there is no coffee capsule or coffee grounds in
your coffee maker, then close the top cover.
5 Plug the power cord into a power outlet, then press both the
CAPSULE and GROUND buttons at the same time. Both
buttons light. Your coffee maker runs five cycles of
approximately 30 seconds each cycle. After the fifth cycle is
complete, your coffee maker automatically turns off.
6 Empty the mug. Use extreme caution because the vinegar may
be hot.
7 Fill the water reservoir with eight ounces of distilled or bottled
water, then run a full brew cycle without a coffee capsule or
coffee grounds.
8 Run three additional brew cycles using fresh distilled or bottled
water each time. Do not use a coffee capsule or coffee grounds.
These additional cycles clean your coffee maker and get rid of
any residual taste from the vinegar or descaling product.
To store your coffee maker:
•
Make sure that all parts are clean and dry before storing.
•
Store your coffee maker in its box or in a clean, dry place.
•
Never store your coffee maker while it is hot or wet.
•
Never wrap the power cord tightly around your coffee maker.
Keep it loosely coiled.
•
Always store your coffee maker in an upright position because
a small amount of water may remain in your coffee maker.
SPECIFICATIONS
Measurements (H × W × D): 12 x 5.5 x 7.3 in (30.6 x 14 x 18.5 cm)
Power: 1,000 Watts
Voltage: 120V / 60Hz
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 877-467-4289 (U.S.) or 01-800-926-3000
(Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its affiliated companies.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2014 Best Buy. All rights reserved.
Made in China
V2 ENGLISH 14-0754
Advertisement
